Anneal-Hardening and -Softening of Aged and Cold-Rolled Cu-Ti Alloys
نویسندگان
چکیده
منابع مشابه
The Anneal Hardening and Deformation Softening Behaviors of Nanocrystalline Cu-Zn Alloys
The changes in the mechanical properties and microstructure of nanocrystalline Cu-Zn alloys deformed by cryorolling during low temperature annealing and the post-process deformation were studied. The deformed Cu-Zn alloys exhibited uncommon anneal hardening and deformation softening behaviors. The degree of anneal hardening and deformation softening increased with the addition of the solute ato...
متن کاملCorrosion Characteristics of a - Ti and Ti 2 Cu Composing Ti - Cu Alloys
A series ef binary Ti-Cu alloys containing 5-20 mass% Cu was prepared, and the corresien behavior of a-Ti and Ti2Cu composing the Ti-Cu alloys were examined based on the anodic polarization curves and released iens in O.9% NaCl and 1% lactic acid solutions. In both selutions, the Ti-Cu alloys showed the same anodic polarization curves as titanium in the conditien below 1.4 V. Hewever, precipita...
متن کاملThe Influence of Processing Conditions on Microchemistry and the Softening Behavior of Cold Rolled Al-Mn-Fe-Si Alloys
Using different homogenization treatments, different initial microchemistry conditions in terms of solid solution levels of Mn, and number densities and sizes of constituents and dispersoids were achieved in an Al-Mn-Fe-Si model alloy. For each homogenized condition, the microchemistry and microstructure, which further change both during deformation and subsequent annealing, were quantitatively...
متن کاملPrecipitation Hardening Behavior of Directly Cold Rolled Al-6Mg Alloy Containing Ternary Sc and Quaternary Zi/Ti
Ageing of 75% cold rolled Al-6Mg alloy with ternary 0.4 wt% scandium and quaternary zirconium and titanium has been carried out. Alloy samples are naturally, isochronally and isothermally aged for different time and temperatures. Hardness values of the differently processed alloys have been measured to understand the ageing behavior of Al-6Mg alloy with scandium and quaternary zirconium and tit...
متن کاملMachinability of Experimental Ti-Cu Alloys
This study is an investigation of the machinability of experimental Ti-Cu alloys (2, 5, and 10mass% Cu) as new dental titanium alloy candidates for CAD/CAM use. The alloys were slotted with a vertical milling machine and carbide square end mills under two cutting conditions. Their machinability was evaluated through cutting force using a three-component force transducer fixed on the table of th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 1974
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet1952.38.7_591