Anisotropic viscous behavior of sheet molding compounds (SMC) during compression molding
نویسندگان
چکیده
منابع مشابه
Volumetrical Characterization of Sheet Molding Compounds
For a comprehensive study of Sheet Molding Compound (SMC) surfaces, topographical data obtained by chromatic confocal imaging were submitted systematically for the development of a profile model to understand the formation of cavities on the surface. In order to qualify SMC surfaces and to predict their coatability, a characterization of cavities is applied. To quantify the effect of surface mo...
متن کاملStress Relaxation in Plastic Molding Compounds
Viscoelastic materials for plastic encapsulated molding compounds invariably exhibit a time-dependent stress response to an imposed constant strain, which is called stress relaxation. Stress relaxation tests with molding compounds used to encapsulate microcircuits have been performed to measure the time dependent non-linear constitutive relation between stress and strain as a function of temper...
متن کاملDesign of a Sensory-based Control System for Compression Molding
The objective of any automatic system is to acquire input data and resolve the output activities in an autonomous and efficient way. Among other control equipment, sensors are an important component of such systems. This work describes the design and implementation of a sensory-based control system for the operation of a compression molding press machine. The overall operation and control is ba...
متن کاملCompression Molding of Phenolic Resin and Corn-based DDGS Blends
With the rapid growth in the ethanol fuel industry in recent years, considerable research is being devoted to optimizing the use of processing coproducts, such as distillers dried grains with solubles (DDGS), in livestock diets. Because these residues contain high fiber levels, they may be amendable to incorporation into biobased composites. Thus, the goal of this study was to demonstrate the v...
متن کاملInjection Compression Molding of Replica Molds for Nanoimprint Lithography
As a breakthrough in the cost and durability of molds for nanoimprint lithography (NIL), replica molds are fabricated by injection compression molding (ICM). ICM is commonly used for optical disks such as DVDs or Blu-ray disks and is also a practical fabrication method for nanostructures. In this paper, I successfully demonstrated the fabrication of cycloolefin polymer replica molds with struct...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Plasticity
سال: 2003
ISSN: 0749-6419
DOI: 10.1016/s0749-6419(01)00077-8