Angiographic film substraction using a laser digitizer and computer processing
نویسندگان
چکیده
منابع مشابه
Laser Digitizer Based Strain Measurement
Automotive sheet panel strain measurement usually involves large surface areas. For high resolution analysis, using the circle grid analysis method, several hundred elements must be measured. Existing technologies are limited to the small surface that area can be measured in one setup. As well, the (X,Y,Z) location on the part is not accurately available. This paper reports a new surface strain...
متن کاملProcessing microstructure on film by femtosecond laser
Selective laser patterning of thin films in a multilayer film is an emerging technology for fabrication of MEMS devices. A 775 nm Ti:sapphire laser (130 fs, 1 kHZ) was used to irradiate the thin film stacks with variations in process parameters such as feed rate and numerical aperture of objective lens. Femtosecond laser patterning of Au/Cr films which have the same thickness of about 1000 nm a...
متن کاملA Portable 3-Dimensional Digitizer for Computer Graphics 3D Modeling
This project created a portable three-dimensional digitizer for computer graphics 3D modeling. It started from reviewing literature then constructed a digitizer, developed applications programs, created experiments and analyzed. The process of the machine started from reading pulse train of the arm rotation via Rotary Encoder at each joint. Next, it was processed by microcontroller and sent the...
متن کاملA Maskless Laser-Write Lithography Processing of Thin-Film Transistors
We report on a fabrication method of the hydrogenated amorphous silicon (a-Si:H) thin-film transistors (TFTs) using a maskless laser-write lithography (LWL). Level-to-level alignment with a high accuracy is demonstrated using LWL method. The obtained results show that it is possible to fabricate a-Si:H TFTs using a well-established a-Si:H TFT technology in combination with the maskless lithogra...
متن کاملDesign of Film Digitizer Equipment and Film Weld DefectRecognition Technology in Pressure Vessel
According to the characteristics of image defects, this paper integrated use of image preprocessing, image segmentation algorithms, expert systems and other methods, presented a film weld defect identification method for non-destructive testing in the pressure vessel weld defect recognition, and to achieve in MATLAB. This paper also described the expert system's basic principles, structure, est...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Digital Imaging
سال: 1998
ISSN: 0897-1889,1618-727X
DOI: 10.1007/bf03178078