Analysis of fiber orientation in injection molding.
نویسندگان
چکیده
منابع مشابه
Improvements in the Simulation of Orientation in Injection Molding of Short Fiber Thermoplastic Composites
The mechanical properties of injection molded short-fiber reinforced thermoplastic composite parts are highly dependent on the orientation distribution of the fibers. A simulation tool capable of predicting fiber orientation accurately as a function of mold design and processing conditions is required as the predicted fiber orientation capabilities in commercial software show large discrepancie...
متن کاملModeling and Simulation of Fiber Orientation in Injection Molding of Polymer Composites
We review the fundamental modeling and numerical simulation for a prediction of fiber orientation during injection molding process of polymer composite. In general, the simulation of fiber orientation involves coupled analysis of flow, temperature, moving free surface, and fiber kinematics. For the governing equation of the flow, Hele-Shaw flow model along with the generalized Newtonian constit...
متن کاملSimulation of Orientation in Injection Molding of a Highly Concentrated, Short Glass Fiber Thermoplastic Composites
This paper presents a 2D coupled Hele-Shaw flow approximation for predicting the flow-induced orientation of injection molded composite parts within a commercial concentration range. For a highly concentrated short glass fiber PBT suspension, the impact of inter-particle interactions and the orientation at the gate is investigated for a center-gated disk using a time-delayed orientation evoluti...
متن کاملStability analysis of injection molding flows
We numerically investigate the stability problem of the injection molding process. It was indicated by Bulters and Schepens Bulters and Schepens 2000 that surface defects of injection molded products may be attributed to a flow instability near the free surface during the filling stage of the mold. We examine the stability of this flow using the extended Pom–Pom constitutive equations. The mode...
متن کاملFiber Orientation in Injection Molded Long Carbon Fiber Thermoplastic Composites
A set of edge-gated and center-gated plaques were injection molded with long carbon fiber-reinforced thermoplastic composites, and the fiber orientation was measured at different locations of the plaques. Autodesk Simulation Moldflow Insight (ASMI) software was used to simulate the injection molding of these plaques and to predict the fiber orientation, using the Anisotropic Rotary Diffusion an...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 1989
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.36.195