ANALYSIS OF CORROSION-RESISTANT TITANIUM ALLOYS DOPED WITH RUTHENIUM BY ICP-AES
نویسندگان
چکیده
منابع مشابه
In vitro corrosion behaviour of titanium alloys without vanadium
The corrosion behaviour of three new non-toxic titanium alloys for use as biomaterials has been investigated. The corrosion current densities of these Ti alloys have low values, indicating a passive state that is stable with time. These values were calculated by using both direct and alternate current methods. The comparison with Ti–6Al–4V, widely used as biomaterial, shows slightly lower corro...
متن کاملThe Analysis of Ecstasy Tablets by Icp/ms and Icp/aes
In this study, tablets coming from different police seizures (in Switzerland) were analysed by ICP/MS and ICP/AES. Two methods of preparation were carried out in order to compare the influence of sample preparation. 25 elements were screened by ICP/AES whereas most of the periodic table could be screened by ICP/MS. Approximative detection limits were determined for most of the elements showing,...
متن کاملCorrosion behavior of pure titanium and titanium alloys in fluoride-containing solutions.
The effects of fluoride concentrations and pH on the corrosion behavior of pure titanium, Ti-6Al-4V, Ti-6Al-7Nb alloys and a new Ti alloy adding palladium, which is expected to promote a repassivation of Ti were examined by anodic polarization and corrosion potential measurements. The amount of dissolved Ti was analyzed by inductively coupled plasma mass spectroscopy. The surface of the specime...
متن کاملNickel-Titanium Alloys: Corrosion “Proof” Alloys for Space Bearing, Components and Mechanism Applications
An intermetallic nickel-titanium alloy, 60NiTi (60wt%Ni, 40wt%Ti), is shown to be a promising candidate tribological material for space mechanisms. 60NiTi offers a broad combination of physical properties that make it unique among bearing materials. 60NiTi is hard, electrically conductive, highly corrosion resistant, readily machined prior to final heat treatment, and is non-magnetic. Despite i...
متن کاملPreparation and Photocatalytic Activity of Potassium-Incorporated Titanium Oxide Nanostructures Produced by the Wet Corrosion Process Using Various Titanium Alloys
Nanostructured potassium-incorporated Ti-based oxides have attracted much attention because the incorporated potassium can influence their structural and physico-chemical properties. With the aim of tuning the structural and physical properties, we have demonstrated the wet corrosion process (WCP) as a simple method for nanostructure fabrication using various Ti-based materials, namely Ti-6Al-4...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Industrial laboratory. Diagnostics of materials
سال: 2018
ISSN: 2588-0187,1028-6861
DOI: 10.26896/1028-6861-2018-84-5-14-19