Analysis of contact melting around a horizontal elliptical cylinder heat source
نویسندگان
چکیده
منابع مشابه
Experimental Study of Heat Transfer around a Cylinder in Presence of Electric Field
In this paper, effects of EHD actuators on hydrodynamic behavior and heat transfer of air flow over a circular cylinder were considered. Pressure and temperature distributions around the cylinder were measured in presence of wire-plate EHD actuators. The Reynolds number based on cylinder diameter (d) were 3500, 7000. Experiments were performed for various configurations. Based on obtained resul...
متن کاملIsogeometric analysis for flows around a cylinder
This note studies the accuracy of Isogeometric Analysis (IGA) applied in the simulation of incompressible flows around a cylinder in two and three dimensions. Quantities of interest, like the drag coefficient, the lift coefficient, and the difference of the pressure between the front and the back of the cylinder are monitored. Results computed with standard finite element methods are used for c...
متن کاملOn the natural convective heat transfer from a cold horizontal cylinder over an adiabatic surface
A steady two-dimensional laminar free convection heat transfer from a cold horizontal isothermal cylinder located above an adiabatic floor is studied both experimentally and numerically. In the experimental measurements the effects of cylinder distance from horizontal floor to its diameter (L/D) on heat transfer coefficient is studied for Rayleigh numbers of 3×105 and 6×105. Computations are ma...
متن کاملdeterminat ion of temperature distribution around a moving heat source
in this paper, the temperature distribution around a moving heat source had been investigated including the phase change and non phase change . in non-phase change state, the governing equation was converted to finite difference equation by finite volume method and the equation was solved by alternating direction implicit method. this method was unconditionally stable . in phase change state, t...
متن کاملSinking of a horizontal cylinder.
We study the sinking of a dense cylinder initially supported horizontally at an air-water interface and then released. The sinking motion is studied experimentally and agrees quantitatively with a simple hydrodynamic model of the process. In particular, our model predicts that the time taken for the cylinder to become immersed in the liquid should be tsink approximately theta((lc/g)1/2), where ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Progress in Natural Science
سال: 2008
ISSN: 1002-0071
DOI: 10.1016/j.pnsc.2007.10.010