Analysis of Compression Coil Springs by Finite Element Method with Joint Elements
نویسندگان
چکیده
منابع مشابه
Helical Coil Suspension Springs in Finite Element Models of Compressors
This paper discusses two approaches to modeling helical suspension springs for use in a dynamic finite element compressor model. The first approach represents the spring's stiffness characteristics with a simple spring element matrix. The appropriate spring constants are calculated using a separate finite element model of the spring. The spring modeling procedure is described and supplemented w...
متن کاملCorrecting the stress-strain curve in hot compression test using finite element analysis and Taguchi method
In the hot compression test friction has a detrimental influence on the flow stress through the process and therefore, correcting the deformation curve for real behavior is very important for both researchers and engineers. In this study, a series of compression tests were simulated using Abaqus software. In this study, it has been employed the Taguchi method to design experiments by the factor...
متن کاملAnalysis of non-connected piled raft foundations (NCPRF) with cushion by finite element method
For the optimum design of Piled Raft Foundations (PRF), the concept of settlement reducer piles has been applied. However, when these piles are connected to the raft, a high stress may develop in the relatively small number of piles. Therefore, an alternative approach is to disconnect the piles from the raft forming a new system called a non-connected or disconnected piled-raft foundation (NCPR...
متن کاملAnalysis of Axisymmetric and Non-Axisymmetric Stretching of Sheet Metals by the Finite Element Method
Stretching process of sheet metals in both cases of axisymmetric and non-axisymmetric is analyzed. A rigid-plastic, normal anisotrop material is assumed and large strain formulation is applied. Triangular elements are used and stiffness equations of elements are obtained from virtual work principle. These nonlinear equations are linearized by Newton-Raphson's method and are solved by Gaussian e...
متن کاملAnalysis of Axisymmetric and Non-Axisymmetric Stretching of Sheet Metals by the Finite Element Method
Stretching process of sheet metals in both cases of axisymmetric and non-axisymmetric is analyzed. A rigid-plastic, normal anisotrop material is assumed and large strain formulation is applied. Triangular elements are used and stiffness equations of elements are obtained from virtual work principle. These nonlinear equations are linearized by Newton-Raphsons method and are solved by Gaussian el...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of Japan Society of Spring Engineers
سال: 1993
ISSN: 0385-6917,1348-1479
DOI: 10.5346/trbane.1993.25