Analysis and optimization of hybrid double lap aluminum-GFRP joints

Experimental Characterization of the Properties of Double-Lap Needled and Hybrid Joints of Carbon/Epoxy Composites

The effect of through-thickness reinforcement by thin 1 mm steel needles (z-pins) on the static tensile strength of double-lap joints of a carbon/epoxy composite was investigated. Two types of joints-z-pinned and hybrid (including glued ones)-were considered. The joints were reinforced in the overlap region with 9, 25, or 36 z-pins. Comparing mechanical properties of the double-lap joints with ...

Investigation on the Effect of Tigthening Torque on the Stress Distribution in Double Lap Simple Bolted and Hybrid (Bolted -Bonded) Joints

In this research, the effects of torque tightening on the stress distribution in double lap simple bolted and hybrid (bolted-bonded) joints have been investigated numerically. In order to determine the bolt clamping force value due to tightening torque in simple bolted and hybrid joints, which is necessary in numerical simulation, an experimental approach has been proposed. To do so, two kinds ...

Fatigue behaviour of composite adhesive lap joints

This paper is concerned with a fatigue study of composite adhesive lap joints produced from a bi-directional woven E-glass fibres and polypropylene. The adhesive used was a Bostik 7452 (Rubber & Plastics Grade) ethyl cyanoacrylate type. The effects of layer orientation, lap joint length and water immersion on the fatigue behaviour were studied. The specimens were immersed in water during period...

Evaluation of Fatigue Life Reduction Factors at Bolt Hole in Double Lap Bolted Joints Using Volumetric Method

In this research, the influence of bolt preload on the fatigue strength of 2024-T3 aluminium alloy double lap bolted joints has been studied experimentally and numerically. To do so, three sets of the specimens were prepared and each of them subjected to tightening torque of 1,2.5 and 5 N-m and then fatigue tests were conducted under various cyclic axial load levels. In the numerical method, th...

Hybrid Modelling of Multilayer Perceptron Ensembles for Predicting the Response of Bolted Lap Joints