Analysis and Measurement of Cutting Temperature under Steady State Cutting
نویسندگان
چکیده
منابع مشابه
Measurement, Analysis and Display of Haptic Signals During Surgical Cutting
The forces experienced while surgically cutting anatomical tissues from a sheep and two rats were investigated for three scissor types. Data were collected in situ using instrumented Mayo, Metzenbaum, and Iris scissors immediately after death to minimize post-mortem effects. The force-position relationship, the frequency components present in the signal, the significance of the cutting rate, as...
متن کاملSteady State Analysis of Nanofuel Droplet Evaporation
The potential for nanofuels as one of the clean sources of energy on account of its enhanced combustion performance coupled with low emissions has been established. Considering the importance of the fuel evaporation phase in the entire combustion process, this work presents an attempt at applying the steady state analysis equations to nanofuel experimental data obtained from the li...
متن کاملStudy of Cutting Temperature in Orthogonal Milling
Finite Element Method (FEM) based techniques are available to simulate metal cutting processes and offer several advantages including prediction of tool forces, distribution of stresses, and temperatures, estimation of tool wear, and residual stresses on machined surfaces, optimization of cutting tool geometry, and cutting conditions. However, work material flow stress and friction characterist...
متن کاملCutting Tool Temperature Analysis in Heat-Pipe Assisted Composite Machining
Machining of advanced materials, such as composite, encounters high cutting temperatures and rapid tool wear because of the abrasive nature of the reinforcement phases in the workpiece materials. Ultrahard coatings, such as chemical vapor deposition diamond, have been used for machining such advanced materials. Wear of diamond-coated tools is characterized by catastrophic coating failure, plaus...
متن کاملExperimental Study of the Effect of Laser-Cutting Process Parameters on Heat Distribution and Cutting Edge Quality of Steel Sheets
This study aimed to evaluate Laser-cutting process of Mild Steel St37 sheets with two different thicknesses. In order to evaluate the quality of cutting edge and the depth of the area affected by the heat, several tests were conducted to determine the effect of parameters such as Laser power, Laser beam movement speed and pressure of axillary gas on the quality of cutting edge and the depth of ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Precision Engineering
سال: 1978
ISSN: 0374-3543
DOI: 10.2493/jjspe1933.44.1424