Analysis And Design Of Steel Plate Shear Walls Using Orthotropic Membrane Model
نویسندگان
چکیده
منابع مشابه
Plastic Analysis and Design of Steel Plate Shear Walls
A revised procedure for the design of steel plate shear walls is proposed. In this procedure the thickness of the infill plate is found using equations that are derived from the plastic analysis of the strip model, which is an accepted model for the representation of steel plate shear walls. Comparisons of experimentally obtained ultimate strengths of steel plate shear walls and those predicted...
متن کاملComparison of plasticity and stiffness of steel shear walls with composite steel plate shear wall
The steel shear wall and composite steel plate shear wall is introduced in recent three decade and is considered and is spread rapidly. Composite steel plate shear wall which is made of a layer of thin steel sheet with coating of reinforced concrete in one or both sides of steel palate is considered a third generation of resistance shear walls against lateral loads that in addition to increasin...
متن کاملFinite Element Analysis of Thin Steel Plate Shear Walls
Steel plate shear walls (SPSWs) in buildings are known to be an effective means for resisting lateral forces. By using un-stiffened walls and allowing them to buckle, their energy absorption capacity will increase significantly due to the postbuckling capacity. The post-buckling tension field action of SPSWs can provide substantial strength, stiffness and ductility. This paper presents the Fini...
متن کاملAnalytical Study on Steel Plate Shear Walls Using Dual Strip Model and 3d Fe Model
Steel plate shear walls (SPSW) have been used as the primary lateral force resisting system in buildings. Extensive analytical studies on steel plate shear walls in the United States, Canada, Taiwan and other countries have already validated the simple analytical model known as strip model to predict the monotonic behavior of this kind of structural system. However, more research is still neede...
متن کاملPlastic Analysis and Design of Steel Plate Shear Walls (2001-2002)
A revised procedure for the design of steel plate shear walls is proposed. In this procedure, the thickness of the infill plate is found using equations that are derived from plastic analysis of the strip model, which is widely accepted for the representation of steel plate shear walls. Equations are derived from a basic steel plate shear wall configuration but are shown to be conservative for ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Engineering
سال: 2011
ISSN: 1877-7058
DOI: 10.1016/j.proeng.2011.07.422