Analysis and Design of Outphasing Transmitter Using Class-E Power Amplifiers With Shunt Capacitances and Shunt Filters
نویسندگان
چکیده
منابع مشابه
OUTPHASING TRANSMITTER An Outphasing Transmitter Using Class - E PAs and Asym - metric Combining : Part
H igh efficiency linear amplification is of great interest in modern communication systems as it increases talk time, decreases power consumption , decreases heat dissipation, and improves reliability. The efficiency of linear power amplifiers (PAs) is highest at the peak output power (PEP) and decreases significantly for low amplitudes, as shown in Figure 1. Signals with time-varying amplitude...
متن کاملLoad Pull Methodology to Characterize Class-E Outphasing Power Amplifiers
A novel load pull methodology to characterize the performance of class-E outphasing power amplifiers is presented. The traditional analysis of the outphasing topology cannot be applied when classE amplifiers are used because these amplifiers do not behave as an ideal current or voltage source. Unlike most other amplifier classes, class-E amplifiers require a phase modulated input signal with co...
متن کاملOUTPHASING TRANSMITTER An Outphasing Transmitter Using Class - E PAs and Asym - metric Combining : Part 2
Second Harmonic Class-E PA Design The selected active device for the transmission-line class-E2 PA is the SD57030 transistor provided by STMicroelectronics. It has a maximum drain voltage of 65 V. In an ideal class-E PA in the optimum operating mode with 50% duty cycle and a slope of zero [5], the peak drain voltage is vDmax =3.56 VDD. Since the peak varies with load impedance, a design for vDm...
متن کاملA Novel Reference Current Calculation Method for Shunt Active Power Filters using a Recursive Algebraic Approach
This paper presents a novel method to calculate the reference source current and the referencecompensating current for shunt active power filters (SAPFs). This method first calculates theamplitude and phase of the fundamental load current from a recursive algebraic approach blockbefore calculating the displacement power factor. Next, the amplitude of the reference mains currentis computed with ...
متن کاملDesign Equations for Class-E Power Amplifiers
In literature, it is widely accepted that the design of Class-E Power Amplifier (PA) with finite dc feed inductance requires a long iterative solution procedure. To avoid such iterative solution methods, analytical design equations should be known. The problem associated with the finite dc feed inductance Class-E PA is usually ascribed to the fact that the circuit element values are transcenden...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Access
سال: 2020
ISSN: 2169-3536
DOI: 10.1109/access.2020.3038584