Analysis and Compensation of Oscillations Induced by Control Valve Stiction
نویسندگان
چکیده
منابع مشابه
Fuzzy gain scheduling of PID controller for stiction compensation in pneumatic control valve
Inherent nonlinearities like, deadband, stiction and hysteresis in control valves degenerate plant performance. Valve stiction standouts as a more widely recognized reason for poor execution in control loops. Measurement of valve stiction is essential to maintain scheduling. For industrial scenarios, loss of execution due to nonlinearity in control valves is an imperative issue that should be t...
متن کاملDetection and Quantification of Control Valve Stiction
Stiction is one of the most common problems in the spring-diaphragm type control valves, which are widely used in the process industry. Although there have been many attempts to understand and detect stiction in control valves, none of the current methods can simultaneously detect and quantify stiction. There is thus a clear need in the process industry for a non-invasive method that can not on...
متن کاملA Control Method Based on Dynamic Response of the Airplane for Compensation of Pilot-Induced Oscillations: Benefits and Flaws
Pilot-Induced Oscillation (PIO) is an unwanted, inadvertent phenomenon that has the ability to damage the aircraft completely. This paper suggests a novel control method that can damp PIO after predicting its occurrence. The specific point of this control algorithm is that it contains a preprocessor that will not let the controller be activated unless in the case of probable PIOs, so pilot comm...
متن کاملQuantification of Valve Stiction
Oscillations in control loops lead to poor controller performance. Stiction in control valves is one of the major causes of such oscillations. Therefore, the correct diagnosis of stiction is important. There are several methods for detecting stiction, but quantification of stiction still remains a challenge. Two parameters are used to model the stiction phenomenon successfully, namely, deadband...
متن کاملModelling Valve Stiction 1
The presence of nonlinearities, e.g., stiction, and deadband in a control valve limits the control loop performance. Stiction is the most commonly found valve problem in the process industry. In spite of many attempts to understand and model the stiction phenomena, there is a lack of a proper model, which can be understood and related directly to the practical situation as observed in real valv...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE/ASME Transactions on Mechatronics
سال: 2016
ISSN: 1083-4435,1941-014X
DOI: 10.1109/tmech.2016.2559510