Analysing a Relationship Between Wheel Wear and Cutting Forces During Diamond Grinding
نویسندگان
چکیده
منابع مشابه
Fractal Analysis of Grain Cutting Edge Wear in Superabrasive Grinding
Abstract This paper deals with a fractal analysis of the wear behavior of the grain cutting edges in superabrasive grinding. Fundamental overcut fly grinding experiments for producing individual straight grooves using a grinding tool with multiple grits are carried out to clarify the wear characteristics of the grain cutting edges in the grinding process and then the change in three-dimensional...
متن کاملNew Diamond Grinding Wheels with Electrically Conductive Cutting Edges
The application of an electrically conductive diamond material to a new type of grinding wheel whose cutting edges possess electrical conductivity has been tried in this research work. Firstly, electrical discharge machining is applied on a solid surface of an electrically conductive CVD diamond film to create protrusions like cutting edges. Secondly, it is confirmed that the EDMed surface of t...
متن کاملVirtual Sensors for On-line Wheel Wear and Part Roughness Measurement in the Grinding Process
Grinding is an advanced machining process for the manufacturing of valuable complex and accurate parts for high added value sectors such as aerospace, wind generation, etc. Due to the extremely severe conditions inside grinding machines, critical process variables such as part surface finish or grinding wheel wear cannot be easily and cheaply measured on-line. In this paper a virtual sensor for...
متن کاملthe investigation of the relationship between type a and type b personalities and quality of translation
چکیده ندارد.
Cutting Forces and Tool Wear Investigation for Face Milling of Bimetallic Composite Parts Made of Aluminum and Cast Iron Alloys
Bimetallic parts are used in many industries for weight and cost reduction of workpieces working under high loads and wear. One application for this type of composite material is in automotive industry. In this work the tool wear and cutting forces in the face milling of bimetallic parts made of aluminum and cast iron were investigated. A356 and GG25 alloys that are common materials for bimetal...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Science and Education of the Bauman MSTU
سال: 2014
ISSN: 1994-0408
DOI: 10.7463/1114.0731997