Analog Circuit Fault Detection Using Relative Amplitude and Relative Phase Analysis
نویسندگان
چکیده
منابع مشابه
Analog Circuit Fault Detection Using Relative Amplitude and Relative Phase Analysis
A new method for detection of parametric faults occurring in analog circuits based on relative amplitude and relative phase analysis of the Circuit Under Test (CUT) is proposed. The relative amplitude is the common power change of the signals and the relative phase presents the relative phase offset of the signals. In the proposed method, the value of each component of the CUT is varied within ...
متن کاملFault Detection in Analog Circuit Using Neural Network
Many studies have been presented for the fault diagnosis of electronic analog circuits. The fault detection using neural network is more efficient than other technique because it has good robustness , strong learning ability and adaptability . neural network need to feed data For initializing the training of neural network.There are the inputs-outputs specified to the neural network. The data f...
متن کاملFault Diagnosis for Analog Circuits by Using EEMD, Relative Entropy, and ELM
This paper presents a novel fault diagnosis method for analog circuits using ensemble empirical mode decomposition (EEMD), relative entropy, and extreme learning machine (ELM). First, nominal and faulty response waveforms of a circuit are measured, respectively, and then are decomposed into intrinsic mode functions (IMFs) with the EEMD method. Second, through comparing the nominal IMFs with the...
متن کاملEffects of relative phase and frequency spacing on the detection of three-component amplitude modulation.
These experiments explored the effect of relative modulator phase on the detection of a three-component modulator applied to a 4,000-Hz sinusoidal carrier with a level of 70 dB SPL. The central modulator component had a frequency of 50 Hz, and the two other components had frequencies of 50+/-5, 10, 25, 40, or 45 Hz. Thus, the modulator waveform was always periodic. Each modulator component had ...
متن کاملAnalog Fault Detection based on Statistical Analysis
In analog circuits, process variations result in physical parameter variations. Simulated values must then be considered with there tolerance intervals. Consequently, contrarily to digital circuits where the outputs are either '0' or '1' such that we can decide without ambiguity whether a fault is detectable or not, for analog circuits the fault detectability is a vague problem as the fault can...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Automatika
سال: 2014
ISSN: 0005-1144,1848-3380
DOI: 10.7305/automatika.2014.12.605