ANALISIS PENGARUH PARAMETER PENGELASAN GTAW PADA STAINLESS STEEL AISI 304 TERHADAP SIFAT MEKANIS DAN STRUKTUR MIKRO
نویسندگان
چکیده
منابع مشابه
Compressibility of 304 Stainless Steel Powder Metallurgy Materials Reinforced with 304 Short Stainless Steel Fibers
Powder metallurgy (P/M) technique is usually used for manufacturing porous metal materials. However, some P/M materials are limitedly used in engineering for their performance deficiency. A novel 304 stainless steel P/M material was produced by a solid-state sintering of 304 stainless steel powders and 304 short stainless steel fibers, which were alternately laid in layers according to mass rat...
متن کاملDesign optimization of cutting parameters for turning of AISI 304 austenitic stainless steel using Taguchi method
In the present work Taguchi method is used to optimize cutting parameters during dry turning of AISI 304 austenitic stainless steel with AlTiCrN coated tool. The coating was deposited on fine-grained K-grade (ISO K-20) cemented carbide cutting insert using physical vapor deposition (PVD) technique. The turning parameters evaluated are cutting speed of 200 and 260 m/min, feed rate of 0.20 and 0....
متن کاملSome Studies on Temperature Distribution Modeling of Laser Butt Welding of AISI 304 Stainless Steel Sheets
In this research work, investigations are carried out on Continuous Wave (CW) Nd:YAG laser welding system after preliminary experimentation to understand the influencing parameters associated with laser welding of AISI 304. The experimental procedure involves a series of laser welding trials on AISI 304 stainless steel sheets with various combinations of process parameters like beam power, beam...
متن کاملEnhancement of corrosion protection of AISI 304 stainless steel by nanostructured sol–gel TiO2 films
0010-938X/$ see front matter 2013 Elsevier Ltd. All rights reserved. http://dx.doi.org/10.1016/j.corsci.2013.07.045 ⇑ Corresponding author. Address: Faculty of Mechanical Engineering and Naval Architecture, Departmet of Materials, Ivana Lučića 5, 10000 Zagreb, Croatia. Tel.: +385 1 616 8313; fax: +385 1 615 7126. E-mail address: [email protected] (L. Ćurković). Lidija Ćurković a,⇑, Helena ...
متن کاملRegression analysis of shot peening process for performance characteristics of AISI 304 austenitic stainless steel
The surface fibers of the material are yielded in tension by the impact of shots in shot peening process. Below the surface fiber an even thin skin surface layer of material is deformed and this layer is highly stressed in compression. It results in the improvement of surface and mechanical properties of the material. Regression analysis is the statistical modeling technique, and it is suitable...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: POROS
سال: 2018
ISSN: 2442-4501,1410-6841
DOI: 10.24912/poros.v15i1.1255