An overview on economic machining of hardened steels by hard turning and its process variables

Process Optimization for Machining of Hardened Steels

an investigation of the impact of self monitoring on langauge teachers motivational practice and its effect on learners motivation

the central purpose of this study was to conduct a case study about the role of self monitoring in teacher’s use of motivational strategies. furthermore it focused on how these strategies affected students’ motivational behavior. although many studies have been done to investigate teachers’ motivational strategies use (cheng & d?rnyei, 2007; d?rnyei & csizer, 1998; green, 2001, guilloteaux & d?...

Investigating Flank Wear and Cutting Force on Hard Steels by CBN Cutting Tool by Turning

In this research work a series of tests were conducted in order to determine flank wear and cutting force FY on hard AISI 440 C martensitic stainless steel and SCM 440 alloy steels. The operating parameters are cutting speed, feed rate and a constant depth of cut to investigate the flank wear and cutting force. No cutting fluid was used during the turning process. The cutting tool used was CBN ...

Tool Damage and Adhesion Effects in Turning and Drilling of Hardened Steels

Noteworthy results have been obtained in the turning and drilling of hardened high-strength steels using tungsten carbide based cutting tools. In a finish turning process, it was seen that surface roughness and tool flank wear followed very different trends against cutting time. The suggested explanation for this behaviour is that the profile cut into the workpiece surface is determined by the ...

Experimental Study of the Cutting Parameters Effect on Hole Making Processes in Hardened Steel

Hardened steels are commonly used in wide areas of technologies and industries. In respect of poor machinability of these steels and requirement of expensive cutting tools, study of machining economy is a matter of importance. Thus the present study deals with the economic considerations of various hole making processes. For this purpose, the hard steel samples were machined by conventional dri...