An Optical Fiber Measurement System for Blade Tip Clearance of Engine
نویسندگان
چکیده
منابع مشابه
An Optical Fiber Bundle Sensor for Tip Clearance and Tip Timing Measurements in a Turbine Rig
When it comes to measuring blade-tip clearance or blade-tip timing in turbines, reflective intensity-modulated optical fiber sensors overcome several traditional limitations of capacitive, inductive or discharging probe sensors. This paper presents the signals and results corresponding to the third stage of a multistage turbine rig, obtained from a transonic wind-tunnel test. The probe is based...
متن کاملAn Experimental Study of Blade Tip Clearance Suction
A computational and experimental study was carried out to determine whether blade tip suction can increase compressor efficiency. Compressor flow fields contain concentrated regions of high entropy fluid near the blade surfaces. Blade suction can remove this fluid, lowering the entropy of the compressor throughflow, thereby avoiding a thermodynamic inefficiency, ultimately raising the compresso...
متن کاملTip-Clearance Measurement in the First Stage of the Compressor of an Aircraft Engine
In this article, we report the design of a reflective intensity-modulated optical fiber sensor for blade tip-clearance measurement, and the experimental results for the first stage of a compressor of an aircraft engine operating in real conditions. The tests were performed in a ground test cell, where the engine completed four cycles from idling state to takeoff and back to idling state. During...
متن کاملTechniques for blade tip clearance measurements with capacitive probes
This article presents a proven but advantageous concept for blade tip clearance evaluation in turbomachinery. The system is based on heavy duty probes and a high frequency (HF) and amplifying electronic unit followed by a signal processing unit. Measurements are taken under high temperature and other severe conditions such as ionization. Every single blade can be observed. The signals are digit...
متن کاملNew Indices for Detection of Turbine blade Tip Deformation and Estimation of Clearance Extent Using Scattering Parameter
Reliability of gas turbine power plant is related to the blade normal operation. In this paper, a new on-line condition monitoring method has been presented to evaluate two important factors affecting the turbine blades that are the tip clearance and tip deformation. A K band’s microwave sensor has been simulated and optimized in CST Microwave Studio software. Scattering parameters of the near...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Aerospace Engineering
سال: 2017
ISSN: 1687-5966,1687-5974
DOI: 10.1155/2017/4168150