An optical fiber Blade Tip Clearance Sensor for Active Clearance Control Applications
نویسندگان
چکیده
منابع مشابه
An Optical Fiber Bundle Sensor for Tip Clearance and Tip Timing Measurements in a Turbine Rig
When it comes to measuring blade-tip clearance or blade-tip timing in turbines, reflective intensity-modulated optical fiber sensors overcome several traditional limitations of capacitive, inductive or discharging probe sensors. This paper presents the signals and results corresponding to the third stage of a multistage turbine rig, obtained from a transonic wind-tunnel test. The probe is based...
متن کاملReal-time Tip-clearance Active Control System
Significance of the Problem Control of blade-tip clearance in the compressor and turbine sections of gas turbine engines can improve efficiency, minimize leakage flow, and shorten engine development time. Tip clearance varies throughout different operating conditions (e.g., start-up, idle, full power, shut-down) because of different radial forces and different thermal expansion coefficients and...
متن کاملAn Experimental Study of Blade Tip Clearance Suction
A computational and experimental study was carried out to determine whether blade tip suction can increase compressor efficiency. Compressor flow fields contain concentrated regions of high entropy fluid near the blade surfaces. Blade suction can remove this fluid, lowering the entropy of the compressor throughflow, thereby avoiding a thermodynamic inefficiency, ultimately raising the compresso...
متن کاملBlade Tip Clearance and Blade Vibration Measurements Using a Magnetoresistive Sensor
A Blade Tip Timing (BTT) system enables the measurement of turbomachinery blade vibrations by means of contactless sensors mounted in the casing. In addition, the so-called Blade Tip Clearance (BTC) measurement system ensures the monitoring of the existing running gaps between the blade tip and the casing. This paper focuses on the results achieved so far using a novel magnetoresistive sensor f...
متن کاملTechniques for blade tip clearance measurements with capacitive probes
This article presents a proven but advantageous concept for blade tip clearance evaluation in turbomachinery. The system is based on heavy duty probes and a high frequency (HF) and amplifying electronic unit followed by a signal processing unit. Measurements are taken under high temperature and other severe conditions such as ionization. Every single blade can be observed. The signals are digit...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Engineering
سال: 2011
ISSN: 1877-7058
DOI: 10.1016/j.proeng.2011.08.182