An On-site Check Methodology of a Particle Number Counting System with a Particle Generator
نویسندگان
چکیده
ABSTRACT: Solid particle number emissions have been regulated in a wide range of automotive fields. Its technical regulations require annual calibration counting system because standard like span gas with known concentration does not exist. However, the fully ensure validity measurements during usage interval. This paper proposes methodology on-site checks generator so that its measurement values can be validated interval calibration.
منابع مشابه
effect of sub-grid scales on large eddy simulation of particle deposition in a turbulent channel flow
چکیده ندارد.
15 صفحه اولa study on construction of iranian life tables: the case study of modified brass logit system
چکیده ندارد.
15 صفحه اولPARTICLE SIZE CHARACTERIZATION OF NANOPARTICLES – A PRACTICALAPPROACH
Abstract: Most properties of nanoparticles are size-dependent. In fact, the novel properties of nanoaprticles do not prevail until the size has been reduced to the nanometer scale. The particle size and size distribution of alumina nanoparticle, as a critical properties, have been determined by transmission electron microscopy (TEM), photon correlation spectroscopy (PCS), surface area analysis ...
متن کاملA New Modified Particle Filter With Application in Target Tracking
The particle filter (PF) is a novel technique that has sufficiently good estimation results for the nonlinear/non-Gaussian systems. However, PF is inconsistent that caused mainly by loss of particle diversity in resampling step and unknown a priori knowledge of the noise statistics. This paper introduces a new modified particle filter called adaptive unscented particle filter (AUPF) to overcome th...
متن کاملDesign and Construction of an Aerosol Particle Classification System Based on Electrical Mobility
Introduction: The application of particles’ electrical mobility in the electric field has always been an important concern, as the functional basis of a number of particle measuring and classification instrumentations. The objective of this study was to design and construct an aerosol particles classification system using electrical mobility feature in laboratory scale. Methodology: This labo...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International journal of automotive engineering
سال: 2023
ISSN: ['2185-0984', '2185-0992']
DOI: https://doi.org/10.20485/jsaeijae.14.2_43