An Improved Model for Camber Generation during Rough Rolling Process
نویسندگان
چکیده
منابع مشابه
Improved Optimization Process for Nonlinear Model Predictive Control of PMSM
Model-based predictive control (MPC) is one of the most efficient techniques that is widely used in industrial applications. In such controllers, increasing the prediction horizon results in better selection of the optimal control signal sequence. On the other hand, increasing the prediction horizon increase the computational time of the optimization process which make it impossible to be imple...
متن کاملCentre-line deviation as a measure of camber in steel slabs during unrestricted horizontal rolling
A theoretical analysis of slab motion during camber evolution in unrestricted horizontal rolling is presented. The analysis shows that a linear relationship exists between centre-line deviation (CLD) curvature and outgoing camber, which is a function of ingoing and outgoing slab thickness and ingoing slab camber. An experimental study, undertaken during commercial rolling at the hot stripmill i...
متن کاملan application of equilibrium model for crude oil tanker ships insurance futures in iran
با توجه به تحریم های بین المملی علیه صنعت بیمه ایران امکان استفاده از بازارهای بین المملی بیمه ای برای نفتکش های ایرانی وجود ندارد. از طرفی از آنجایی که یکی از نوآوری های اخیر استفاده از بازارهای مالی به منظور ریسک های فاجعه آمیز می باشد. از اینرو در این پایان نامه سعی شده است با استفاده از این نوآوری ها با طراحی اوراق اختیارات راهی نو جهت بیمه گردن نفت کش های ایرانی ارائه نمود. از آنجایی که بر...
An improved second generation wave model
• Abstract: A numerical second-generation sea wave model (SG) is presented and applied to December 1992 events on Mediterranean Sea. The energy advection is performed using a semiLagrangian scheme. The wind sea is generated by surface wind data supplied by a global/limited area atmospheric model or global analysis. The source terms (generation, dissipation and nonlinear interactions) are tuned ...
متن کاملDevelopment of a Predictive Finite Element Model For Investigation of Phases Behavior After Cold Rolling Process
One of the surface defects that arise in sheet metal working is when the part removes from the die. Since there are no external forces to make this defect, the origin of such fail is known as residual stress. Residual stress can develop in sheet metal forming due to non uniform deformation. In this paper, the workpiece is carbon steel with different volume fractions and arrangement of ferrite ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ISIJ International
سال: 2015
ISSN: 0915-1559,1347-5460
DOI: 10.2355/isijinternational.isijint-2015-088