An improved cutting force model for micro milling considering machining dynamics
نویسندگان
چکیده
منابع مشابه
Fuzzy cutting force modelling in micro-milling
Reliable prediction of cutting forces is essential for micromilling. In this paper, a fuzzy cutting force modelling method based on subtractive clustering method filters the noise and estimates the instantaneous cutting forces using observations acquired by sensors during cutting experiments. In the experimental case study, four data sets of micromilling cutting force are used. Each data set is...
متن کاملPrediction of Chatter in CNC Machining based on Dynamic Cutting Force for Ball End Milling
This paper presents the suitable depth of cut, spindle speed and feed rate that will be chosen during machining. If thus parameters are not considered, this can provoke abnormal tool behavior such as chatter. Chatter will limit the tool life which only can be use for just a few times. To predict the chatter occurs, the parameters will be use are spindle speed, depth of cut and feed rate. CNC ma...
متن کاملModeling micro-end-milling operations. Part I: analytical cutting force model
A new analytical cutting force model is proposed for micro-end-milling operations. The model calculates the chip thickness by considering the trajectory of the tool tip while the tool rotates and moves ahead continuously. The proposed approach allows the calculation of the cutting forces to be done accurately in typical micro-end-milling operations with very aggressively selected feed per tooth...
متن کاملInfluence of machining cycle of horizontal milling on the quality of cutting force measurement for the cutting tool wear monitoring
The cutting tools are today used a lot by industry and they are expensive, so it was interesting to optimize their use, by developing a predictive method of their wear, particularly, the flank wear Vb. For this task, the flank tool wear was measured in off-line using a binocular microscope, whereas, the cutting forces are recorded by means of a dynamometer (Kistler 9255B). The acquired signatur...
متن کاملFuzzy cutting force modelling in micro-milling using subtractive clustering for learning evaluation
Cutting forces prediction is very important for cutting tool’s design and process planning. This paper presents a fuzzy cutting force modelling method using subtractive clustering for learning evaluation. In this method, subtractive clustering, combined with the least-square algorithm, identifies the fuzzy prediction model directly from the information obtained from the sensors. In the micro-mi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The International Journal of Advanced Manufacturing Technology
سال: 2017
ISSN: 0268-3768,1433-3015
DOI: 10.1007/s00170-017-0706-2