An extended Marciniak–Kuczynski model for anisotropic sheet subjected to monotonic strain paths with through-thickness shear
نویسندگان
چکیده
منابع مشابه
Crack Tip Constraint for Anisotropic Sheet Metal Plate Subjected to Mode-I Fracture
On the ground of manufacturing, sheet metal parts play a key role as they cover about half of the production processes. Sheet metals are commonly obtained from rolling and forming processes which causes misalignment of micro structure resulting obvious anisotropic characteristics and micro cracks. Presence of micro cracks poses serious attention, when stresses at the tip reach to the critical v...
متن کاملBending-Unbending Analysis of Anisotropic Sheet under Plane Strain Condition
The mechanical behavior of cold rolled sheets is significantly related to residual stresses that arise from bending and unbending processes. Measurement of residual stresses is mostly limited to surface measurement techniques. Experimental determination of stress variation through thickness is difficult and time-consuming. This paper presents a closed form solution for residual stresses, in whi...
متن کاملBending-Unbending Analysis of Anisotropic Sheet under Plane Strain Condition
The mechanical behavior of cold rolled sheets is significantly related to residual stresses that arise from bending and unbending processes. Measurement of residual stresses is mostly limited to surface measurement techniques. Experimental determination of stress variation through thickness is difficult and time-consuming. This paper presents a closed form solution for residual stresses, in whi...
متن کاملAn Elasticity Solution for Static Analysis of Functionally Graded Curved Beam Subjected to a Shear Force
In this paper, using 2-D theory of elasticity, a closed-form solution is presented for stressdistributions and displacements of a FG curved beam under shear force at its free end. The materialproperties are assumed to vary continuously through the radial direction based on a simple power lawmodel and Poisson’s ratio is supposed to be constant. In order to verify the solution, it is shown that a...
متن کاملThrough-Thickness Stresses in Automotive Sheet Metal after Plane Strain Channel Draw
Abstract. A series of samples from four automotive materials AKDQ, HSLA50, DP600, and AA6022-T43 were deformed in a channel draw processes with different levels of draw bead penetration. As a result, varying magnitudes of deformations in plane strain mode and residual stresses were obtained. Through-thickness stress profiles were obtained non-destructively using a novel, high resolution X-ray d...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Plasticity
سال: 2011
ISSN: 0749-6419
DOI: 10.1016/j.ijplas.2011.03.008