AN EXPERIMENTAL STUDY ON ELASTIC-PLASTIC LATERAL-TORSIONAL BUCKLING OF H-SHAPED STEEL BEAM-COLUMNS PERMITTED TO SWAY

The effect of discrete lateral and torsional bracings stiffness on the elastic lateral-torsional buckling of mono-symmetric I beam, under the concentrated moment

When the out-of-plane stiffness of a beam is remarkably lower than the in-plane stiffness, the lateral-torsional buckling occurs. In this study, the behavior of mono-symmetric I-beams with discrete torsional and lateral bracings under the concentrated moment is investigated using the finite element analyses. Then, based on the numerical analyses, equation for the stiffness requirement is propos...

Lateral Torsional Buckling of Steel Thin-Walled Beams with Lateral Restraints

Metal thin-walled members have been widely used in building industry. Usually they are utilized as purlins, girts or ceiling beams. Due to slenderness of thin-walled cross-sections these structural members are prone to stability problems (e.g. flexural buckling, lateral torsional buckling). If buckling is not constructionally prevented their resistance is limited by buckling strength. In practi...

Advanced Analysis of Steel Frame Structures Subjected to Lateral Torsional Buckling Effects

Lateral-torsional buckling resistance of cold-formed high strength steel rectangular hollow beams

Hollow sections have been widely used for steel structures. Applications of High Strength Steel (HSS) on cold-formed hollow sections lead to thinner and lighter structures. This paper presents numerical investigations on the lateral-torsional buckling resistance of the cold-formed high strength steel rectangular hollow beam. Results from finite element analysis using Abaqus software are compare...

Experimental Study of the Seismic Performance of L-Shaped Columns with 500 MPa Steel Bars

Based on tests on six L-shaped RC columns with 500 MPa steel bars, the effect of axial compression ratios and stirrup spacing on failure mode, bearing capacity, displacement, and curvature ductility of the specimens is investigated. Test results show that specimens with lower axial load and large stirrup characteristic value (larger than about 0.35) are better at ductility and seismic performan...