An Environmental and Cost Analysis of Stamping Sheet Metal Parts
نویسندگان
چکیده
منابع مشابه
Identifying Sources of Variation in Sheet Metal Stamping
Manufacturers using traditional process control charts to monitor their sheet metal stamping processes often encounter out-of-control signals indicating that the process mean has changed. Unfortunately, a sheet metal stamping process does not have the necessary adjustability in its process variable input settings to allow adjusting the mean response in an out-of-control condition, hence the sig...
متن کاملAn Experimental Study of Springback of Bent Sheet Metal Parts
Bending is the uniform straining of material around a straight axis and is used commonly in various sheet metal industrial products. Since all materials have a finite modulus of elasticity, plastic deformation is followed by some elastic recovery when the load is removed. In bending processes this phenomenon is called springback. Springback occurs not only in flat sheets or plate, but also in b...
متن کاملA mechanics model for sheet-metal stamping using deformable dies
This paper studied the deformation mechanisms of sheet metals stamped by rigid punches and deformable dies. Emphasis was placed on the development of elastic plastic zones in the sheet workpieces, on the functions of the die parameters and on their correlations with spring-back. It was found that the reduction of spring-back was due mainly to the interface interaction offered by the dies. The p...
متن کاملOn the Topology of Sheet Metal Parts
Abstract This paper analyzes the topological properties of sheet metal parts represented schematically (zero thickness, zero bend radii). Although such parts are usually non-manifold objects, the paper establishes a general topological invariant f = s + b + e + w v gnm + m regarding the number of facets, components, bends, free edges, welds, vertices holes and volumes, respectively. Correspondi...
متن کاملForming of Multi layer Sheet Metal by Drawing Process: an Analysis and FEM Simulation
In this paper, the drawing process of multi-layer sheet metal through wedge shaped die has been analyzed using stream function and upper bound method. Typically a sandwich sheet contains three layers of metal, where the outer layers are of the same thickness and material and different from those of the inner layer. In this study, a new deformation model has been introduced in which inlet and ou...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Manufacturing Science and Engineering
سال: 2016
ISSN: 1087-1357,1528-8935
DOI: 10.1115/1.4034670