An augmented Lagrangian treatment of the metal forming process
نویسندگان
چکیده
منابع مشابه
Investigation of hot metal gas forming process of square parts
Aluminum alloys are considered a lot in the automotive and aerospace industry because of their high strength to weight ratio. In this manuscript, the gas forming process of aluminum AA6063 tubes at high temperatures up to 500°C is investigated, through experimental and numerical tests. Therefore, an experimental setup is prepared and so, tube specimens are formed in a die with square cross sect...
متن کاملForming of Multi layer Sheet Metal by Drawing Process: an Analysis and FEM Simulation
In this paper, the drawing process of multi-layer sheet metal through wedge shaped die has been analyzed using stream function and upper bound method. Typically a sandwich sheet contains three layers of metal, where the outer layers are of the same thickness and material and different from those of the inner layer. In this study, a new deformation model has been introduced in which inlet and ou...
متن کاملReliability analysis of the metal forming process
In this paper, we propose a reliability–mechanical study combination for treating the metal forming process. This combination is based on the augmented Lagrangian method for solving the deterministic case and the response surface method. Our goal is the computation of the failure probability of the frictionless contact problem. Normally, contact problems in mechanics are particularly complex an...
متن کاملAn Augmented Lagrangian Approach to Constrained MAP Inference An Augmented Lagrangian Aproach to Constrained MAP Inference
In this section, we derive in detail the closed form solution of problem (12) for binary pairwise factors (Sect. 4.1). Recall that the marginal polytope M(G a) is given by:
متن کاملOptimality properties of an Augmented Lagrangian method
Sometimes, the feasible set of an optimization problem that one aims to solve using a Nonlinear Programming algorithm is empty. In this case, two characteristics of the algorithm are desirable. On the one hand, the algorithm should converge to a minimizer of some infeasibility measure. On the other hand, one may wish to find a point with minimal infeasibility for which some optimality condition...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Mathematical and Computer Modelling
سال: 2000
ISSN: 0895-7177
DOI: 10.1016/s0895-7177(00)00198-9