An analytical solution for a plane thermal stress problem expressed in elliptical coordinates. (3rd Report. Steady-state thermal stresses in a confocal hollow elliptical plate).
نویسندگان
چکیده
منابع مشابه
Stress Analysis in Thermosensitive Elliptical Plate with Simply Supported Edge and Impulsive Thermal Load
The paper concerns the thermoelastic problems in a thermosensitive elliptical plate subjected to the activity of a heat source which changes its place on the plate surface with time. The solution of conductivity equation and the corresponding initial and boundary conditions is obtained by employing a new integral transform technique. In addition, the intensities of bending moments, resultant fo...
متن کاملQuasi-Static Transient Thermal Stresses in an Elliptical Plate due to Sectional Heat Supply on the Curved Surfaces over the Upper Face
This paper is an attempt to determine quasi-static thermal stresses in a thin elliptical plate which is subjected to transient temperature on the top face with zero temperature on the lower face and the homogeneous boundary condition of the third kind on the fixed elliptical curved surface. The solution to conductivity equation is elucidated by employing a classical method. The solution of stre...
متن کاملSteady Thermal Stresses in a Thin Rotating Disc of Finitesimal Deformation with Mechanical Load
Seth’s transition theory is applied to the problems of thickness variation parameter in a thin rotating disc by finite deformation. Neither the yield criterion nor the associated flow rule is assumed here. The results obtained here are applicable to compressible materials. If the additional condition of incompressibility is imposed, then the expression for stresses corresponds to those arising ...
متن کاملMechanical and Thermal Stresses In a Linear Plastic FGM Hollow Cylinder Due to Axisymmetric Loads
In this paper, an analytical solution for computing the linear plastic stresses and critical temperature and pressure in a FGM hollow cylinder under the internal pressure and temperature is developed. It has been assumed that the modulus of elasticity and thermal coefficient of expansion were varying through thickness of the FGM material according to a power law relationship. The Poisson's rati...
متن کاملMechanical and Thermal Stresses in a FGPM Hollow Cylinder Due to Non-Axisymmetric Loads
In this paper, the general solution of steady-state two-dimensional non-axisymmetric mechanical and thermal stresses and mechanical displacements of a hollow thick cylinder made of fluid-saturated functionally graded porous material (FGPM) is presented. The general form of thermal and mechanical boundary conditions is considered on the inside and outside surfaces. A direct method is used to sol...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
سال: 1989
ISSN: 0387-5008,1884-8338
DOI: 10.1299/kikaia.55.293