AN ANALYSIS OF TUNNEL EXCAVATION BY LIMIT ANALYSIS CONSIDERING STRAIN SOFTENING
نویسندگان
چکیده
منابع مشابه
an infinite planar array of rectangular microstrip patch antenna analysis
the methods which are used to analyze microstrip antennas, are divited into three categories: empirical methods, semi-empirical methods and full-wave analysis. empirical and semi-empirical methods are generally based on some fundamental simplifying assumptions about quality of surface current distribution and substrate thickness. thses simplificatioms cause low accuracy in field evaluation. ful...
15 صفحه اولFinite Element Method Analysis of Influence on Subway Tunnel Adjacent to Excavation by Excavation Construction
The interaction influence on subway tunnels adjacent to foundation excavation was produced by excavation construction, and it is great significance for the correct assessment of its size and influence on the safety of subway operation. Based on the foundation excavation project, some typical foundation excavation profiles are selected, the calculation and analysis on additional settlement and h...
متن کاملNonlinear Analysis of Strain-Softening Damage
The paper reviews the modeling of damage by the microplane model and presents extensions required for cyclic loading. The general microplane constitutive model is implemented in a three-dimensional finite element code and used in damage and bifurcation analysis of various structures. The results of the analysis are compared with test results and some of the comparisons are shown in the present ...
متن کاملRoof Tunnel Stability by Wedge Analysis
A jointed rock mass presents a more complex design problem than the other rock masses. The complexity arises from the number (greater than two) of joint sets which define the degree of discontinuity of medium. The condition that arises in these types of rock masses is the generation of discrete rock blocks, of various geometries. They defined by the natural fracture surfaces and the excavation...
متن کاملDetermination of Buckling Limit of Strain in Cold Roll Forming through Finite Element Analysis
In this study, Buckling Limit of Strain (B.L.S.) is introduced as one of the most important limiting factors in cold roll forming process. B.L.S. is calculated by the finite element procedure. Then for two particular processes with existing analysis and experimental results, B.L.S. has been determined and evaluated. LUSAS 12.3 is used for finite element analysis. The results show that when buck...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Proceedings of the Japan Society of Civil Engineers
سال: 1983
ISSN: 1884-4936,0385-5392
DOI: 10.2208/jscej1969.1983.331_103