An Algorithm of Bearing Fault Diagnosis Classifier Design
نویسندگان
چکیده
منابع مشابه
Rolling Bearing Fault Analysis by Interpolating Windowed DFT Algorithm
This paper focuses on the problem of accurate Fault Characteristic Frequency (FCF) estimation of rolling bearing. Teager-Kaiser Energy Operator (TKEO) demodulation has been applied widely to rolling bearing fault detection. FCF can be extracted from vibration signals, which is pre-treatment by TEKO demodulation method. However, because of strong noise background of fault vibration signal, it is...
متن کاملdesign of an analog fuzzy logic controller chip
fuzzy logic has been developed over the past three decades into a widely applied techinque in classification and control engineering. today fuzzy logic control is one of the most important applications of fuzzy set theory and specially fuzzy logic. there are two general approachs for using of fuzzy control, software and hardware. integrated circuits as a solution for hardware realization are us...
15 صفحه اولFault Detection of Bearings Using a Rule-based Classifier Ensemble and Genetic Algorithm
This paper proposes a reduct construction method based on discernibility matrix simplification. The method works with genetic algorithm. To identify potential problems and prevent complete failure of bearings, a new method based on rule-based classifier ensemble is presented. Genetic algorithm is used for feature reduction. The generated rules of the reducts are used to build the candidate base...
متن کاملRigorous Design of a Fault Diagnosis and Isolation Algorithm
UNU/IIST UNU/IIST enables developing countries to attain self-reliance in software technology by: (i) their own development of high integrity computing systems, (ii) highest level postgraduate university teaching, (iii) international level research, and, through the above, (iv) use of as sophisticated software as reasonable. UNU/IIST contributes through: (a) advanced, joint industry{university ...
متن کاملBearing Fault Diagnosis Based on Vibration Signals
The vibration signal obtained from operating machines contains information relating to machine condition as well as noise. Further processing of the signal is necessary to elicit information particularly relevant to bearing faults. Many techniques have been employed to process the vibration signals in bearing faults detection and diagnosis. Two common techniques, time domain techniques and freq...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: DEStech Transactions on Environment, Energy and Earth Science
سال: 2017
ISSN: 2475-8833
DOI: 10.12783/dteees/edep2016/5951