An Active Inductor Based Low Noise Amplifier for RF Receiver
نویسندگان
چکیده
منابع مشابه
Active Inductor based Low Noise Amplifier for Ultra Wide Band Receiver
In this paper a three stage Active Inductor (AI) based Low Noise Amplifier (LNA) for Ultra Wide Band (UWB) receiver is presented. A fully differential topology has been adopted in order to improve the circuit robustness against unwanted common mode signals. T-coil peaking is used to enhance the bandwidth over the entire Ultra Wide Band frequency range. Active inductor is employed because of its...
متن کاملA 1.7 – 2.5 GHz Active Inductor based Low Power Low Noise Amplifier for Multi Standard Applications
Due to an increasing demand for simultaneous global roaming and all-in-one wireless phones, the interest in the development of the multi-standard transceivers has been increased. In the receiver front end, the performance of Low Noise Amplifier (LNA) decides overall receiver sensitivity and hence its design plays a crucial role. In this paper, an active inductor based tunable two-stage LNA empl...
متن کاملActive Inductor Designs for RF CMOS Receiver Front - End
Inductors are a necessary building block in many circuits, including LNA and oscillators largely used in Receivers and various other systems. Because planer inductors can occupy a large amount of area in integrated-circuit (IC) designs, the search has been on for smaller, tunable inductors suitable for monolithic fabrication In this paper a method, which is to implement an active inductor by CM...
متن کاملActive inductor-based tunable impedance matching network for RF power amplifier application
This paper presents the use of a new structure of active inductor named cascoded flippedactive inductor (CASFAI) in a T-type high-pass tunable output matching network of a class-E RF power amplifier (RFPA) to control the output power and enhance the efficiency. The designed CASFAI behaves as an inductor in the frequency range of 0-6.9 GHz, and has reached to a maximum quality factor of 4406, in...
متن کاملA Low Noise Amplifier Optimized for a GPS Receiver RF Front End
A cascode LNA was optimized for a GPS receiver radio frequency front end using a 0.18 μm CMOS technology. By careful choice of device geometry, gate and source degeneration inductors, a fully integrated LNA can be optimized to have a low noise figure, a high voltage gain and a wide dynamic range. The optimized LNA has a 1.512 dB noise figure, a –42.05 dB S11, a 20.04 dB voltage gain a –19.82 dB...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Electronics and Electrical Engineering
سال: 2013
ISSN: 2029-5731,1392-1215
DOI: 10.5755/j01.eee.19.5.2158