An Absorptive Frequency Selective Reflector With Wide Reflection Band
نویسندگان
چکیده
منابع مشابه
3-Port Frequency-Selective Absorptive Limiter*
This paper describes a novel 3-port absorptive limiter for frequency selective circuits based on a configuration similar to a conventional 90o hybrid coupler. This circuit uses the switching behavior of common diodes to change between the nonlimiting and absorptive limiting states. Theoretical descriptions and designs are presented along with prototypes based on PIN diodes. Measurements of the ...
متن کاملDesign of an S-band Ultra-low-noise Amplifier with Frequency Band Switching Capability
In this paper, an ultra-low-noise amplifier with frequency band switching capability is designed, simulated and fabricated. The two frequency ranges of this amplifier consist of the 2.4 to 2.5 GHz and 3.1 GHz to 3.15 GHz frequency bands. The designed amplifier has a noise figure of less than 1dB, a minimum gain of 23 dB and a VSWR of less than 2 in the whole frequency band. The design process s...
متن کاملA boundary that sustains a negligible specular reflection coefficient over a wide frequency band
In a previous paper the authors analyzed and discussed the specular reflection coefficient of a plane boundary comprised of a plate, a compliant layer, and a fluid. The analysis showed that a negligible specular reflection coefficient may be derived provided specific resonance conditions are met. The resonance of concern is that between the surface mass of the plate and the surface stiffness of...
متن کاملStudy on Dual Wide Band Frequency Selective Surface for Different Incident Angles
This paper deals with single layer Frequency selective surface (FSS) which acts as a double band reject filter. The two stop bands are really broad with percentage bandwidth of 26.67% and 14.53%. The maximum and minimum band separation for this proposed design is around 45 dB and frequency ratio is more than 1.9.This results are almost same for different incident angles.. This design is investi...
متن کاملNew UWB Shielding with Frequency Selective Surfaces
In this paper a Frequency Selective Surface (FSS) as a UWB electromagnetic shield is introduced. The proposed FSS comprises a quasi-J.C-Jerusalem Cross- and a copper ring, which are located at both sides of a FR4 substrate and can represent a S.E -Shielding Effectiveness- better than 20dB in 90% bandwidth of Ultra Wide Band frequency. This structure is compact and thin. Each cell comprises J.C ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Access
سال: 2020
ISSN: 2169-3536
DOI: 10.1109/access.2020.2971010