Amorphous film coating by low pressure plasma spraying. Application of plasma spraying with functional materials.
نویسندگان
چکیده
منابع مشابه
Plasma spraying and characterization of chromium carbide – nickel chromium coatings
Chromium carbide – nickel chromium powder Cr3C2-25wt.NiCr was plasma sprayed by a water-stabilized system WSP®. A series of experiments with variable feeding distance was carried out. Basic characterization of coatings was done by XRD, SEM and light microscopy plus image analysis. Microhardness was measured on polished cross sections. The main focus of investigation was on resistances against w...
متن کاملMicrostructure and Property of Zr-Based Metallic Glass Coating Formed by Gas Tunnel Type Plasma Spraying
Metallic glass has excellent functions such as high strength and high corrosion resistance. Therefore, it is one of the most attractive materials, and various developmental research works have been conducted by many researchers. However, the metallic glass material is expensive to use, and a composite material is preferred for the industrial application. Thermal spraying method is one of potent...
متن کاملFormation and Properties of Ni-Based Amorphous Metallic Coating Produced by HVAF Thermal Spraying
A highly dense Ni59Zr20Ti16Si2Sn3 partial amorphous metallic coating, about 500mm thick, was fabricated by means of HVAF (High Velocity Air Fuel) thermal spraying. Amorphous alloy powders produced by using gas atomization were used for HVAF thermal spraying to produce an amorphous metallic coating. Microstructural investigation showed that crystallization and oxidation occurred during thermal s...
متن کاملPlasma lignocaine concentrations following endotracheal spraying with an aerosol.
Plasma concentrations of lignocaine were measured in three groups of anaesthetized patients following spraying of the trachea and larynx with a lignocaine 10% aerosol spray. Greater venous plasma concentrations occurred in patients who were paralysed with suxamethonium. A mean plasma concentration of 0.1 mug/ml of lignocaine resulted from each 10 mg of lignocaine used in spontaneously breathing...
متن کاملCoating of Carbon Fibre Reinforced PEEK Implants with Titanium by Vapour Plasma Spraying for Improved Bone Apposition
Introduction: The success of an orthopaedic implant depends on several factors, such as implant material properties, design and fixation technique as well as bone apposition around the implant. Polyetheretherketone (PEEK) is a composite thermoplastic biomaterial exhibiting biochemical and biomechanical properties suitable for load-bearing orthopaedic implants. Two advantages of carbon fibre rei...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Surface Finishing Society of Japan
سال: 1990
ISSN: 0915-1869,1884-3409
DOI: 10.4139/sfj.41.1012