Aluminum matrix composites using a continuous Si-Ti-C-O fiber.
نویسندگان
چکیده
منابع مشابه
Photoelectrochemical Water Splitting Properties of Ti-Ni-Si-O Nanostructures on Ti-Ni-Si Alloy
Ti-Ni-Si-O nanostructures were successfully prepared on Ti-1Ni-5Si alloy foils via electrochemical anodization in ethylene glycol/glycerol solutions containing a small amount of water. The Ti-Ni-Si-O nanostructures were characterized by field-emission scanning electron microscopy (FE-SEM), energy dispersive spectroscopy (EDS), X-ray diffraction (XRD), and diffuse reflectance absorption spectra....
متن کاملReactive Sintering of TiAl - Ti 5 Si 3 Lnsitu Composites
TiAl with between 0 and 20 volume percent (v%)Ti5Si3 was produced by reactive sintering of cofd pressed compacts of elemental Ti, Al and Si powder mixtures at 7OO0C for 15 minutes in vacuum. The results show that adding Si to Ti and A1 reduces the swelling associated with reactive sintering of TiAI, as composites containing more than 5 vYoTigSi3 densified during reactive sintering. However, com...
متن کاملMultifunctional nanostructured Ti-Si-C thin films
In this Thesis, I have investigated multifunctional nanostructured Ti-Si-C thin films synthesized by magnetron sputtering in the substrate-temperature range from room temperature to 900 °C. The studies cover high-temperature growth of Ti3SiC2 and Ti4SiC3, low-temperature growth of Ti-Si-C nanocomposites, and Ti-Si-C-based multilayers, as well as their electrical, mechanical, and thermal-stabili...
متن کاملBi-continuous metal matrix composites
Bi-continuous alumina/aluminium composites were made by infiltrating an alumina preform which had the structure of a reticulated ceramic foam. The low density preforms were prepared from a polyurethane suspension of alumina powder which was pyrolysed and sintered after foaming. Higher density preforms consisted of ceramic foams with open cells. All these preforms were infiltrated with 6061 alum...
متن کاملInvestigation of Parameters Involved in the Production of Aluminum Matrix Composites Using Hot Powder Extrusion
Aluminum matrix composites reinforced with Al2O3 and SiC particles (5 Vol%) were produced using the hot powder extrusion method. Extrusion temperature and extrusion reduction in area were chosen in the range of 500 to 600°C and 90 to 95%, respectively. The physical and mechanical properties of the extruded composites such as density, tensile strength, elongation and microhardness were evaluated...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 1990
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.37.980