ALUMINUM AND STEEL WELDING WITH 500 W FIBRE LASER
نویسندگان
چکیده
The study of the process laser welding various aluminum-steel joints is necessary to promote possibility realization new products and designs in instrumentation mechanical engineering. Laser welding, due its many advantages, considered a very promising joining different materials, although application industry still limited. Welding aluminum with steel using sources challenging task mainly formation brittle intermetallic (IMC) at joint interface. This paper aims give brief overview some research on steel, as well point out our initial laboratory this direction.[1]
منابع مشابه
Analysis and Comparison of Friction Stir Welding and Laser Assisted Friction Stir Welding of Aluminum Alloy
Friction Stir Welding (FSW) is a solid-state joining process; i.e., no melting occurs. The welding process is promoted by the rotation and translation of an axis-symmetric non-consumable tool along the weld centerline. Thus, the FSW process is performed at much lower temperatures than conventional fusion welding, nevertheless it has some disadvantages. Laser Assisted Friction Stir Welding (LAFS...
متن کاملKeyhole behaviour during laser welding of zinc-coated steel
The production of consistent, high-quality laser welds on zinc-coated steels for the automotive industry remains a challenge. A simple overlap joint geometry is desirable in these applications but has been shown to be extremely detrimental to laser welding because the zinc vapour formed at the interface between the two sheets expands into the keyhole and disrupts fluid flow in the melt pool, wh...
متن کاملEffect of Laser Welding on Formability of DP980 steel
Limiting dome height (LDH) tests were used to evaluate the formability of laser butt welded blanks of the dual phase 980 steel in comparison with the base metal. Two different lasers were used: diode and Nd:YAG, giving a wide range of welding thermal cycles. A sharp decrease in LDH was observed in the welded specimens due to the formation of a softened zone in the outer heat affected zone. Soft...
متن کاملFabrication of synchronized hammer peening with pulsed laser welding and its effect on 6061 aluminum alloy weld
The non-continuous laser beam in pulsed lasers allows the mechanical peening between two consecutive beams on a still hot weld bead. At a very short time (20, 150 and 300 ms) after laser pulse application, mechanical peening was performed on the welding bead. To achieve these short times, the light sensor detects the nth laser pulse and the mechanical arm starts moving. Upon reaching the tip of...
متن کاملFabrication of Aluminum Foam-Filled Thin-Wall Steel Tube by Friction Welding and Its Compression Properties
Aluminum foam has received considerable attention in various fields and is expected to be used as an engineering material owing to its high energy absorption properties and light weight. To improve the mechanical properties of aluminum foam, combining it with dense tubes, such as aluminum foam-filled tubes, was considered necessary. In this study, an aluminum foam-filled steel tube, which consi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Cilv?ks. Vide. Tehnolo?ijas
سال: 2023
ISSN: ['2592-8597']
DOI: https://doi.org/10.17770/het2022.26.6947