Aluminium-Silicon-Magnesium Filler Metal for Aluminium Vacuum Brazing Wettability and Characteristics of Brazing Microstructure
نویسندگان
چکیده
منابع مشابه
Wettability of Brazing Filler Metals on Copper and Copper Alloys
The possibility of alloying can not be avoided at the interface between molten brazing filler metal and base metal in brazing, so the wettability of brazing filler metal can not be easily explained theoretically. We used the original apparatus for wettability test and investigated the relation between the wettability of brazing filler metals of Ag-P-Cu and Ag-Cu-Zn-Cd systems on copper and the ...
متن کاملVacuum Brazing of Zirconium-Based Alloy and 321 Stainless Steel Using Titanium Based Filler Metal
Both Zirconium-based alloys and 321stainless steel are widely used as engineering alloys due to their good mechanical properties. Conventional fusion welding techniques for Zr alloys and stainless steel are not feasible due to the formation of brittle intermetallic compounds such as (Zr3Fe, ZrFe2 and Zr2Fe) and corrosion cracking. Brazing is one of the most wide...
متن کاملThe Microstructural Evolution of Vacuum Brazed 1Cr18Ni9Ti Using Various Filler Metals
The microstructures and weldability of a brazed joint of 1Cr18Ni9Ti austenitic stainless steel with BNi-2, BNi82CrSiBFe and BMn50NiCuCrCo filler metals in vacuum were investigated. It can be observed that an interdiffusion region existed between the filler metal and the base metal for the brazed joint of Ni-based filler metals. The width of the interdiffusion region was about 10 μm, and the mic...
متن کاملActive vacuum brazing of CNT films to metal substrates for superior electron field emission performance
The joining of macroscopic films of vertically aligned multiwalled carbon nanotubes (CNTs) to titanium substrates is demonstrated by active vacuum brazing at 820 °C with a Ag-Cu-Ti alloy and at 880 °C with a Cu-Sn-Ti-Zr alloy. The brazing methodology was elaborated in order to enable the production of highly electrically and thermally conductive CNT/metal substrate contacts. The interfacial ele...
متن کاملDeveloping and Easing the Brazing Method
Brazing generally require cumbersome apparatus be it induction, vacuum or torch brazing. In torch brazing, metals are joined by using the oxyacetylene cylinder. It thus becomes difficult to carry out brazing at the places where it is not possible to take heavy gas cylinders and brazing apparatuses. So it is tried to figure out the method to carry out brazing at places where conventional brazing...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATERIALS TRANSACTIONS
سال: 2016
ISSN: 1345-9678,1347-5320
DOI: 10.2320/matertrans.m2016004