Alumina Fibers

Preparation and characterization of highly thulium- and alumina-doped optical fibers for single-frequency fiber lasers

Thulium-doped fibers suitable for core-pumped single-frequency lasers were fabricated by the modified chemical vapor deposition (MCVD) method. Refractive index profile, doping profile and spectral absorption was measured. High doping concentration of thulium ions should be achieved to allow for high absorption of light at a pump wavelength while the thulium ions clustering should be avoided to ...

Alumina-debris-induced osteolysis in contemporary alumina-on-alumina total hip arthroplasty. A case report.

Gum Tragacanth Fibers Introducing Primitive GT Fibers (RESEARCH NOTE)

In this research, a method for producing gum tragacanth (GT) fibers is presented. Ribbon type GT of Astragalus Gummifer species were obtained from local production lands. The gum was treated with alkali to increase its process ability, and allowed to stand for a period of time to reach the proper viscosity and/or to "ripen". Samples with different ripening times were prepared and their viscosit...

FABRICATION OF CARBON FIBERS FROM COMMERCIAL WET SPIN POLYACRYLONITRILE FIBERS

Carbon fibers are fabricated from different materials such as special polyacrylonitrile (PAN) fibers, cellulose fibers and pitch. But PAN fibers are recognized as the most widely used precursor for the present-day manufacture of carbon fibers. The process of fabrication carbon fibers from special PAN fibers is composed of two steps including oxidative stabilization at low temperature and carbon...

Microseparation and stripe wear in alumina-on-alumina hip implants.

The combination of materials that still has highest wear resistance for total hip replacement is ceramic-on-ceramic. However, brittleness is a major concern for ceramics: in vivo and in vitro studies on ceramic hip prostheses correlate microseparation with hip noise, ceramic wear, or ceramic liner damage. Ceramic microseparation can lead to edge load, ceramic head wear, and squeaking. The aim o...