All-Surface Induction Heating With High Efficiency and Space Invariance Enabled by Arraying Squircle Coils in Square Lattice
نویسندگان
چکیده
منابع مشابه
Wireless Metal Detection and Surface Coverage Sensing for All-Surface Induction Heating
All-surface induction heating systems, typically comprising small-area coils, face a major challenge in detecting the presence of a metallic vessel and identifying its partial surface coverage over the coils to determine which of the coils to power up. The difficulty arises due to the fact that the user can heat vessels made of a wide variety of metals (and their alloys). To address this proble...
متن کاملAll-Photonic Link for High-Performance Antenna Arraying
A stabilized all-photonic link is described that significantly simplifies X-band (approximately 8 to 12.5 GHz) and Ka-band (approximately 18 to 40 GHz) signal transport for high-performance antenna array applications. A cost-effective, integrated fiber-optic calibration technology provides long-term phase stability in the actual link used for broadband signal transport. This should directly ben...
متن کاملInduction heating of aluminium billets using superconducting coils
It is proposed to apply high-temperature superconducting (HTS) tape in the coil windings for induction heaters for aluminium or copper extrusion billets. The potential for efficiency improvements is substantial, as conventional copper coil induction heaters rated for up to around 1 MW operate with an overall efficiency of typically only 50–60%. The efficiency of a HTS induction heater depends v...
متن کاملElastic Waves Induced by Surface Heating in a Half-Space
Rapid surface heating will induce waves in an elastic material. Closed form solutions for the resulting longitudinal and transverse thermal stresses are derived using Laplace Transforms. The model is one-dimensional, consisting of a half-space subjected to a step change in the surface heating. The transverse stress at the wave peak is found to exceed the surface stress for short times, while fo...
متن کاملSquare lattice photonic crystal surface mode lasers.
In this report, we propose a square lattice photonic crystal hetero-slab-edge microcavity design. In numerical simulations, three surface modes in this microcavity are investigated and optimized by tuning the slab-edge termination τ and gradual mirror layer. High simulated quality (Q) factor of 2.3 × 10(5) and small mode volume of 0.105 μm(3) are obtained from microcavity with τ = 0.80. In expe...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Consumer Electronics
سال: 2018
ISSN: 0098-3063,1558-4127
DOI: 10.1109/tce.2018.2859627