All-Solid-Sate pH Electrode Using Li2O-Y2O3-SiO2 Glass
نویسندگان
چکیده
منابع مشابه
Microstructure and Properties of Li2O-Al2O3-SiO2-P2O5 Glass-Ceramics
Serials Li2O–Al2O3–SiO2 matrix glasses and glass-ceramics with different content of P2O5 were prepared by conventional melt cooling method and crystallization process. The effects of P2O5 content on microstructure and properties such as viscosity, melting temperature and coefficient of thermal expansion (CTE) of Li2O–Al2O3–SiO2–P2O5 glasses and glass-ceramics were investigated by DSC, XRD, CTE ...
متن کاملCharacterizing the residual glass in a MgO/Al2O3/SiO2/ZrO2/Y2O3 glass-ceramic
The non-isochemical crystallization of glasses leads to glass-ceramics in which the chemical composition of the amorphous matrix differs from that of the parent glass. It is challenging to solely analyse the properties of these residual glassy phases because they frequently contain finely dispersed crystals. In this study, the composition of the residual glass matrix after the crystallization o...
متن کاملSynthesis and Characterization of Y2O3/SiO2 Composites
Impregnation and deposition-precipitation syntheses have been used to obtain Y2O3/SiO2 samples. In the deposition method, the urea causes the precipitation of yttrium hydroxide, which leads to the formation of yttria nanocrystalline particles in the final composites. Delaying the silica addition up to the visible muddying of the solution, a relevant formation of yttria nanocrystalline particles...
متن کاملThermal analysis of Li2O TeO2 glass
The thermal properties of 0.30Li2O 0.70TeO2 glass are studied. Speci®c heat, Cp, is measured in the 170°C < T < 270°C interval. The Einstein temperature, hA 840 K, is determined from the temperature course of Cp. In the glass transition interval, the heat capacity undergoes an S-shaped transition from the value, Cgl, of the glass to that of undercooled melt, Cp. It is found that Cgl=Cp 0:62. ...
متن کاملAll-solid-state potassium-selective electrode using graphene as the solid contact.
Graphene sheets are used for the first time to fabricate a new type of solid-contact ion-selective electrode (SC-ISE) as the intermediate layer between an ionophore-doped solvent polymeric membrane and a glassy carbon electrode. The new transducing layer was characterized by transmission electron microscopy, scanning electron microscopy, cyclic voltammetry and electrochemical impedance spectros...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Ceramic Society of Japan
سال: 2005
ISSN: 0914-5400,1882-1022
DOI: 10.2109/jcersj.113.550