Alkali Activation of Copper and Nickel Slag Composite Cementitious Materials
نویسندگان
چکیده
منابع مشابه
EFFECTS OF SILICA MODULUS AND ALKALI CONCENTRATION ON ACTIVATION OF BLAST-FURNACE SLAG
Abstract: The use of alkali-activated cementitious materials especially over the past decades has significantly been increased. The goal of this research is to investigate the effects of silica modulus and alkali concentration on alkali-activation of blast-furnace slag. In this research, the most important physical characteristics of cementitious systems, i.e. the 28-day compressive strength...
متن کاملFabrication and Mechanical Properties of Iron Slag Matrix Composite Materials
–The objective of present work is to use this industrial waste i.e. Slag as particulate filler material to the epoxy matrix composites by molding technique with different weight fractions ( 0%, 5%,10%,15%, 20% ) to study the mechanical behaviour of reinforced polymer composite material. The change in weight is studied for Slag under different tests like, tensile, bending and impact for obtainin...
متن کاملDurability of Mortar Incorporating Ferronickel Slag Aggregate and Supplementary Cementitious Materials Subjected to Wet–Dry Cycles
This paper presents the strength and durability of cement mortars using 0–100% ferronickel slag (FNS) as replacement of natural sand and 30% fly ash or ground granulated blast furnace slag (GGBFS) as cement replacement. The maximum mortar compressive strength was achieved with 50% sand replacement by FNS. Durability was evaluated by the changes in compressive strength and mass of mortar specime...
متن کاملUtilization of Soil Stabilization with Cement and Copper Slag as Subgrade Materials in Road Embankment Construction
In this study, unconfined compression tests have been conducted to investigate the impacts of copper slag on mechanical characteristics for stabilized cement and un-stabilized soil. Dozens of specimens were prepared at four percentages of cement (i.e. 0%, 2%, 4% and 6%) and five percentages of copper slag (i.e. 0%, 5%, 10%, 15% and 20%) by weight of dry soil. The samples compacted into a cylind...
متن کاملRecovery of Copper from Copper Slag and Copper Slag Flotation Tailings by Oxidative Leaching
Copper smelter slag and copper smelter slag flotation tailings were leached using sulphuric acid solutions, without or with the addition of either ferric sulphate or hydrogen peroxide. Copper extraction from the slag was typically found to be twice as high as that from the slag flotation tailings. Hydrogen peroxide was determined to be the best lixiviant. Thus, copper and iron extractions were ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials
سال: 2020
ISSN: 1996-1944
DOI: 10.3390/ma13051155