Air-Breathing Aqueous Sulfur Flow Battery for Ultralow-Cost Long-Duration Electrical Storage
نویسندگان
چکیده
منابع مشابه
Alkaline Benzoquinone Aqueous Flow Battery for LargeScale Storage of Electrical Energy
The replacement of fossil fuel energy with renewable sources has been increasing as the cost of solar and wind energy falls rapidly. Recent reports show that from 2008 to 2015, the cost of wind generation fell by 41%, rooftop solar photovoltaic installations by 54%, and utility-scale photovoltaic installations by 64%. The cost of solar panels now takes up less than 30% of a fully installed sola...
متن کاملRedox Flow Battery for Energy Storage
To realize a low-carbon society, the introduction of renewable energies, such as solar or wind power, is increasingly being promoted these days worldwide. A major challenge presented by solar and wind power generators is their fluctuation in output. If they are introduced in large numbers to the power system, problems, such as voltage rises, frequency fluctuations and surplus of the generated p...
متن کاملA high-rate and long cycle life aqueous electrolyte battery for grid-scale energy storage.
New types of energy storage are needed in conjunction with the deployment of solar, wind and other volatile renewable energy sources and their integration with the electric grid. No existing energy storage technology can economically provide the power, cycle life and energy efficiency needed to respond to the costly short-term transients that arise from renewables and other aspects of grid oper...
متن کاملElectrical energy storage for the grid: a battery of choices.
The increasing interest in energy storage for the grid can be attributed to multiple factors, including the capital costs of managing peak demands, the investments needed for grid reliability, and the integration of renewable energy sources. Although existing energy storage is dominated by pumped hydroelectric, there is the recognition that battery systems can offer a number of high-value oppor...
متن کاملElaboration and characterization of a free standing LiSICON membrane for aqueous lithium-air battery
In order to develop a LISICON separator for an aqueous lithium-air battery, a thin membrane was prepared by a tape-casting of a Li1.3Al0.3Ti1.7 (PO4)3−AlPO4 based slip followed by a sintering step. By optimizing the grain sizes, the slip composition and the sintering treatment, the mechanical properties were improved and the membrane was reduced to a thickness of down to 40 μm. As a result, the...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Joule
سال: 2017
ISSN: 2542-4351
DOI: 10.1016/j.joule.2017.08.007