AEROACOUSTIC RESPONSE OF ISOLATED CYLINDER(S) IN CROSS-FLOW AT DIFFERENT LOCATIONS INSIDE A RECTANGULAR DUCT
نویسندگان
چکیده
منابع مشابه
Lower Mode Response of Circular Cylinders in Cross-Flow
Transverse amplitude responses ofa circular cylinder in cross-flow were determined as a function of reduced velocities for a variety of spring constants and damping coefficients. Maxima were found at reduced velocities of 5 and 16, and were of comparable amplitude. The first resonance, designated the "fundamental mode, " was due to normal vortex street excitation of the spring-mass system. The ...
متن کاملHeat Transfer from a Tube Bank in Cross Flow in a Duct
An experimental investigation on heat transfer coefficient is presented from three horizontal tubes in a vertical array in a duct for 500<ReD<6000. A mass transfer measuring technique based on psychrometry chart is used to determine heat transfer coefficient. The diameter of the tubes is 11 mm each spaced 40 mm apart and in-line pitch ratio varies 
in the range 0.055<D/W<0.22. The experimen...
متن کاملHeat Transfer from a Tube Bank in Cross Flow in a Duct
An experimental investigation on heat transfer coefficient is presented from three horizontal tubes in a vertical array in a duct for 500<ReD<6000. A mass transfer measuring technique based on psychrometry chart is used to determine heat transfer coefficient. The diameter of the tubes is 11 mm each spaced 40 mm apart and in-line pitch ratio varies in the range 0.055<D/W<0.22. The experimenta...
متن کاملFluid flow and heat transfer characteristics in a curved rectangular duct using Al2O3-water nanofluid
In the present research, the laminar forced convective heat transfer and fluid flow characteristics for Al2O3-water nanofluid flowing in different bend (i.e., 180o and 90o) pipes have been investigated numerically in a three-dimensional computational domain using the finite volume technique. The effects of different pertinent parameters, such as the Reynolds number of the duct, volume fraction ...
متن کاملDrag coefficient and strouhal number analysis of a rectangular probe in a two-phase cross flow
In some case of laboratory and industrial applications, various kind of measurement instruments must be placed in a conduit, in which multiphase fluid flows. Vortex shedding for any immersed body in flow field is created with a frequency, which according to flow conditions such as flow rates, geometry of body, etc. may be constant or variable. Failure may happen, if this frequency is close to o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The International Conference on Applied Mechanics and Mechanical Engineering
سال: 2014
ISSN: 2636-4360
DOI: 10.21608/amme.2014.35536