AE in Bending Fatigue Process of Carburizing Spur Gears.
نویسندگان
چکیده
منابع مشابه
The source of Acoustic Emission during meshing of spur gears
Condition monitoring of gears with vibration analysis and Spectrometric Oil Analysis Programs (SOAP) are widely accepted and used in the military aviation industry. Whilst the literature to date has shown the application of the Acoustic Emission (AE) technique to gearbox health monitoring still be in its infancy, there exist opportunities to develop the technique into a complementary diagnostic...
متن کاملCAD-based simulation of the hobbing process for the manufacturing of spur and helical gears
Targeting an accurate and realistic simulation of the gear hobbing process, we present an effective and factual approximation based on three-dimensional computer-aided design. Hobbing kinematics is directly applied in one gear gap. Each generating position formulates a spatial surface path which bounds its penetrating volume into the workpiece. The three-dimensional surface paths generated from...
متن کاملInfluence of dynamic behaviour on elastohydrodynamic lubrication of spur gears
In this study, the elastohydrodynamic lubrication (EHL) behaviour of high-speed spur gear contacts is investigated under dynamic conditions. A non-linear time-varying vibratory model of spur gear pairs is introduced to predict the instantaneous tooth forces under dynamic conditions within both the linear and non-linear operating regimes. In this model, the periodically time-varying gear mesh st...
متن کاملEfficiency and Temperature of Spray Lubricated Superfinished Spur Gears
Gearboxes are one of the most power dense systems used today, and in certain instances their limiting factor is the ability to evacuate heat from the gear contact. This work analyses the efficiency (i.e. heat generation) and tooth temperature in the three lubricating conditions dip, into mesh spray and out of mesh spray for superfinished gears which are then compared to ground gears. A back-to-...
متن کاملInfluence of Addendum Modification Factor on Root Stresses in Normal Contact Ratio Asymmetric Spur Gears
Tooth root crack is considered as one of the crucial causes of failure in the gearing system and it occurs at the tooth root due to an excessive bending stress developed in the root region. The modern power transmission gear drives demand high bending load capacity, increased contact load capacity, low weight, reduced noise and longer life. These subsequent conditions are satisfied by the aid o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 1995
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.61.417