Advanced Finite Element Analysis and Simulation in Superplastic Forming Process of Stepped Semispherical Die
نویسندگان
چکیده
منابع مشابه
Finite Element Simulation of Superplastic Forming Using a Microstructure Based Constitutive Model
In this paper, Finite Element simulations using ABAQUS are carried out to optimize and simulate the superplastic forming of Ti-6Al-4V sheet at 900 °C. Microstructure-based constitutive models describing the superplastic deformation are implemented in the FE code through user defined subroutines. Two different forming schemes are used; constant strain rate scheme and optimum variable strain rate...
متن کاملProcess Simulation for Optimizing Superplastic Forming of Sheet Metal
Superplastic forming (SPF) is conducted in a heated, pressurized die where direct monitoring of critical SPF parameters is extremely difficult. Numerical models provide a critical means of tracking the forming process, allowing the applied gas pressure to be adjusted to maintain optimum SPF behavior throughout the forming process. This paper describes how the MARC finite element code was used t...
متن کاملAnalysis of Roll Wear in Reshaping Using Finite Element Simulation
Reshaping process is a widely used method for producing tubes with non-circular cross sections. Owing to the friction between pipe and rolls, initial round pipe moves forward and consequently, it gradually formed into square or rectangular one. In practice, geometric profile of the rolls will be changed after a while. These changes would be detrimental the production of faultless products. Ther...
متن کاملDetermination of Buckling Limit of Strain in Cold Roll Forming through Finite Element Analysis
In this study, Buckling Limit of Strain (B.L.S.) is introduced as one of the most important limiting factors in cold roll forming process. B.L.S. is calculated by the finite element procedure. Then for two particular processes with existing analysis and experimental results, B.L.S. has been determined and evaluated. LUSAS 12.3 is used for finite element analysis. The results show that when buck...
متن کاملFinite element simulation of two-point incremental forming of free-form parts
Two-point incremental forming method is considered a modern technique for manufacturing shell parts. The presence of bottom punch during the process makes this technique far more complex than its conventional counterpart i.e. single-point incremental forming method. Thus, the numerical simulation of this method is an essential task, which leads to the reduction of trial/error costs, predicts th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Applied Sciences
سال: 2012
ISSN: 1812-5654
DOI: 10.3923/jas.2012.1048.1052