Adiabatic circuits: converter for static CMOS signals
نویسندگان
چکیده
منابع مشابه
Power Dissipation analysis of Conventional CMOS and Adiabatic CMOS circuits
In recent years, low power circuit design has been an important issue in VLSI design areas. If the power consumption is less, then the amount of power dissipation is also less. Energy recovery adiabatic logic circuit is a low power design solution. Adiabatic circuits are those circuits which work on the principle of adiabatic charging and discharging. These circuits recycle the energy from outp...
متن کاملTesting for parametric faults in static CMOS circuits
Many defects causing bridges, breaks, and transistor stuck-ons in static CMOS circuits are not detected by tests generated using the traditional single stuck-at fault model. These undetected, non-traditional faults may be detected as increased propagation time or as excessive quiescent power supply current (I DDQ). In this paper we compare the cost of testing for excess I DDQ caused by bridge, ...
متن کاملStatic Simulation of CNTFET-based Digital Circuits
In this paper we implement a simple DC model for CNTFETs already proposed by us in order to carry out static analysis of basic digital circuits. To verify the validity of the obtained results, they are compared with those of Wong model, resulting in good agreement, but obtaining a lighter ensuring compile and shorter execution time, which are the main character...
متن کاملRegister Design for Adiabatic Circuits
In adiabatic switching [1], the registers as part of the circuitry, up to now have not been examined very well. Known approaches will be either only partially adiabatic [2], or integral part of the combinatorial logic, making automatic design hard [8, 5]. They are, however, a crucial part of the design. First, because in the registers information is stored, so here all the problems connected wi...
متن کاملOptimized Standard Cell Generation for Static CMOS Technology
Fabrication of an integrated circuit with smaller area, besides reducing the cost of manufacturing, usually causes a reduction in the power dissipation and propagation delay. Using the static CMOS technology to fabricate a circuit that realizes a specific logic function and occupies a minimum space, it must be implemented with continuous diffusion runs. Therefore, at the design stage, an Euleri...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advances in Radio Science
سال: 2003
ISSN: 1684-9973
DOI: 10.5194/ars-1-247-2003