ADI after Austenitising from Intercritical Temperature
نویسندگان
چکیده
منابع مشابه
Grain Growth after Intercritical Rolling
The distribution of the characteristic texture components between the ferrite grains of different size classes has been studied in a steel with 0.082%C, 1.54% Mn, 0.35% Si, 0.055%Nb and 0.078%V after different rolling schedules with a final rolling temperature above or below Ar3. Microstructures and textures were characterized by means of optical microscopy and orientation microscopy. A strong ...
متن کاملProposal of an empirical formula for the austenitising temperature
A formula is proposed to calculate the chemical austenitising temperature derived by means of a neural network model. A wide range of compositions were used, allowing to predict changes of tendency in the slopes of the austenitisation temperature, consistent with the existence of a eutectoid composition.
متن کاملAustenite formation during intercritical annealing
Purpose: of this paper is the effect of the soft annealing of initial microstructure of the 6Mn16 steel on the kinetics of the austenite formation during next intercritical annealing. Design/methodology/approach: Analytical TEM point analysis with EDAX system attached to Philips CM20 was used to evaluate the concentration of Mn, Ni and Cr in the microstructure constituents of the multiphase ste...
متن کاملThe Ductile to Brittle Transition Temperature of Unalloyed Adi Material
In material selection, especially in low temperature conditions, one of very important factors it is a ductile to brittle transition temperature, i.e. the temperature when material becomes too brittle to use. In this paper transition temperature determined by impact energy in temperature interval from –196 to +100°C of unalloyed austempered ductile iron with different microstructures have been ...
متن کاملDevelopment of High Silicon Dual Phase Austempered Ductile Iron
This work deals with the feasibility of obtaining Austempered Ductile Iron with Dual Phase structures (DPADI) through heat treatment, starting from different as-cast microstructures. The mechanical properties on these microstructures were evaluated. DPADI microstructures were obtained by adding different tenors of silicon (2.4% to 4.2%) to the melts and keeping the other alloying elements const...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Archives of Foundry Engineering
سال: 2013
ISSN: 1897-3310
DOI: 10.2478/afe-2013-0016