Adhesive Contact of Nanowire in Three-Point Bending Test
نویسندگان
چکیده
منابع مشابه
Crackling noise in three-point bending of heterogeneous materials.
We study the crackling noise emerging during single crack propagation in a specimen under three-point bending conditions. Computer simulations are carried out in the framework of a discrete element model where the specimen is discretized in terms of convex polygons and cohesive elements are represented by beams. Computer simulations revealed that fracture proceeds in bursts whose size and waiti...
متن کاملFlexural Properties and Fracture Behavior of Nanoporous Alumina film by Three-Point Bending Test
This study investigated the influence of porosity on the flexural property of a nanoporous alumina film. When the porosity of the alumina film increased, both bending strength and modulus declined. The results from the bending test revealed that the setting of the film during the bending test had significant influence on the flexural property. Fracture only occurred when the porous side of the ...
متن کاملAdhesive contact in filaments
This paper studies the elastic contact in filaments induced by surface adhesion, which plays an important role in the mechanical response of fibrous materials (e.g., fiber friction, sliding, compression hysteresis, etc.). During the process, a simple 3D elastic contact model was proposed. The filaments were assumed to be uniform, smooth elastic cylinders, and the adhesive force between filament...
متن کاملBamboo Taper Effect on Third Point Loading Bending Test
Abstract—Geometrical shape of bamboo usually assumed as tapered hollow pipe. This study proved that the dimensional changes along the bamboo stem significantly affected to its Modulus of Rupture (SR) value which measured from third point loading bending test. Therefore if the bending test applied using third point loading configuration, the SR value should be adjusted by strength ratio of taper...
متن کاملCluster Analysis of Acoustic Emission Signals for Carbon/Epoxy Composite in Four-point Bending Test (RESEARCH NOTE)
Due to the extensive use of composites in various industries and the fact that defects reduce ultimate strength and efficiency during operation, detection of failures in composite parts is very important. The aim of this paper is to use Acoustic Emission (AE) non-destructive method in four-point bending test of carbon/epoxy composite to analyze and examine the failure mechanisms. This method is...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Adhesion Science and Technology
سال: 2011
ISSN: 0169-4243,1568-5616
DOI: 10.1163/016942410x549898