Adhesion forces for water/oil droplet and bubble on coking coal surfaces with different roughness
نویسندگان
چکیده
منابع مشابه
Capillary forces between surfaces with nanoscale roughness.
The flow and adhesion behavior of fine powders (approx. less than 10 microm) is significantly affected by the magnitude of attractive interparticle forces. Hence, the relative humidity and magnitude of capillary forces are critical parameters in the processing of these materials. In this investigation, approximate theoretical formulae are developed to predict the magnitude and onset of capillar...
متن کاملForces Acting on Sessile Droplet on Inclined Surfaces
Although many analytical, experimental and numerical studies have focused on droplet motion, the mechanics of the droplet while still in its static state, and just before motion starts, are not well understood. A study of static droplets would shed light on the threshold voltage (or critical inclination) for initiating electrically (or gravitationally) induced droplet motion. Before the droplet...
متن کاملInfluence of roughness on capillary forces between hydrophilic surfaces.
Capillary forces have been measured by atomic force microscopy in the plate-sphere setup between gold, borosilicate glass, GeSbTe, titanium, and UV-irradiated amorphous titanium-dioxide surfaces. The force measurements were performed as a function contact time and surface roughness in the range 0.2-15 nm rms and relative humidity ranging between 2% and 40%. It is found that even for the lowest ...
متن کاملScattering from Surfaces with Different Roughness Scales: Analysis and Interpretation
This paper discusses several approaches to scattering from slightly rough» very rough, composite, and rough spherical surfaces. Average incoherent scattering cross sections for slightly rough surfaces are obtained using a perturbation technique for a perfect conductor, and for a surface material which is homogeneous (with variable permeability, \Lr, as well as permittivity, «r)« The results, co...
متن کاملRoughness Model for Adhesion Testing of Pharmaceutical Coating Materials
Objective Roughness is the main parameter in interlocking bonding mechanism. Yet there is no model designed to evaluate the effect of surface roughness on adhesion of coating materials in pharmaceutical sciences. Materials and Methods In this study polymethyl metacrylate spherical beads with different sizes were poured into 10 mm mold, then it was pressed by hand screw and finally heated to 141...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Mining Science and Technology
سال: 2021
ISSN: 2095-2686
DOI: 10.1016/j.ijmst.2021.03.002