Adaptive Control Based Velocity and Pressure Control for Injection Molding Cylinder
نویسندگان
چکیده
منابع مشابه
A Comparison of Velocity to Pressure Transfer Control Strategies for Injection Molding
Injection molders commonly use a ram position setting to control switchover. As in-mold sensors have become more widespread, using them to control switchover ensures more consistent part quality than machine-based control. Herein we explore several control strategies applied to an array of different mold configurations and materials. We evaluate each method's ability to minimize in-cavity varia...
متن کاملConception of Cylinder Pressure Based Diesel Injection Control System
Control of diesel fuel injection is very important and has influence not only at engine operating conditions but also at emission of toxic gases as NOx, HC, and Particulate Matter (PM) are effect of combustion process. Directly observing of combustion process is very difficult, but implementation to injection control algorithm procedures based on additional sensors as knock sensor, cylinder pre...
متن کاملPrecision Injection Molding PRECISION PROCESS CONTROL OF INJECTION MOLDING
1 INTRODUCTION The technical requirements of precision injection molded components demand a heightened level of process performance, and with corresponding process monitoring and control technologies. To obtain the desired critical to quality attributes (CTQs) of the molded products, the injection molding process must be consciously designed such that the key process variables (KPVs) are observ...
متن کاملFuzzy Sliding Mode Control for Enhancing Injection Velocity Performance in Injection Molding Machine
In this study, injection velocity in injection molding process was analyzed. Since physical behavior of thermoplastic and environmental condition in injection machine such as high temperature and pressure make a complex dynamics in injection molding system, the injection velocity is consequently difficult to control by some classical control methods. Hence, robust and adaptive control (Fuzzy Sl...
متن کاملFPGA-Based Multiprocessor System for Injection Molding Control
The plastic industry is a very important manufacturing sector and injection molding is a widely used forming method in that industry. The contribution of this work is the development of a strategy to retrofit control of an injection molding machine based on an embedded system microprocessors sensor network on a field programmable gate array (FPGA) device. Six types of embedded processors are in...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of The Korean Society for Fluid Power & Construction Equipments
سال: 2012
ISSN: 2234-8328
DOI: 10.7839/ksfc.2012.9.3.001