Active Microwave Pulse Compressor Using an Electron-Beam Triggered Switch
نویسندگان
چکیده
منابع مشابه
Microwave growth from the beam breakup instability in long-pulse electron beam experiments
The beam breakup (BBU) instability has been investigated in high-current, long-pulse electron beams propagating through microwave cavities. Experiments are performed using a relativistic electron-beam generator with diode parameters: 0.7-0.8 MV, 1-15 kA, and OS-l.5 ps. The magnitude of the solenoidal magnetic field places these experiments in an intermediate regime between strong focusing and w...
متن کاملMeasurements of Photon Beam Flattening Filter Using an Anisotropic Analytical Algorithm and Electron Beam Employing Electron Monte Carlo
Introduction: This study aimed to report the measurement of photon and electron beams to configure the Analytical Anisotropic Algorithm and Electron Monte Carlo used in clinical treatment. Material and Methods: All measurements were performed in a large water phantom using a 3-dimensional scanning system (PTW, Germany). ...
متن کاملActive RF Pulse Compression Using Electrically Controlled Semiconductor Switch
First we review the theory of active pulse compression systems using resonant delay lines. Then we describe the design of an electrically controlled semiconductor active switch. The switch comprises an active window and an overmoded waveguide three-port network. The active window is based on a four-inch silicon wafer which has 960 PIN diodes. These are spatially combined in an overmoded wavegui...
متن کاملActive negative-index metamaterial powered by an electron beam
M. A. Shapiro,1 S. Trendafilov,2 Y. Urzhumov,3 A. Alù,4 R. J. Temkin,1 and G. Shvets2,* 1Plasma Science and Fusion Center, Massachusetts Institute of Technology, Cambridge, Massachusetts 02139, USA 2Department of Physics, The University of Texas at Austin, Austin Texas 78712, USA 3Center for Metamaterials and Integrated Plasmonics, Pratt School of Engineering, Duke University, Durham, North Car...
متن کاملDesign of Pulse Triggered Flip Flop Using Pulse Enhancement Scheme
For the past several years, much progress has been made in Low power VLSI Design .In This paper ,a novel low-power pulse Triggered flipflop design is presented. First, the pulse generation control logic an AND function, is removed from critical path to facilitate a faster discharge operation. A simple two-transistor AND gate design is used to reduce the circuit complexity. Second, a conditional...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Physical Review Letters
سال: 2013
ISSN: 0031-9007,1079-7114
DOI: 10.1103/physrevlett.110.115002