Active Control of Cable and Cable-Structure System
نویسندگان
چکیده
منابع مشابه
An Aerostat Positioning System with Cable Control
The capabilities of a tri-tethered aerostat positioning system are investigated using simulations of a comprehensively validated dynamics model. The physical system studied consists of a payload supported by a helium filled aerostat and attached to three anchored ground tethers actuated using winches. Closed-loop control is achieved by feeding back the position of a payload located at the confl...
متن کاملActive Tendon Control of Cable-stayed Bridges: Theory and Implementation
This paper presents a strategy for active damping of cablestayed bridges, using active tendons. The first part of the paper summarizes the theoretical background: the control law is briefly presented together with the main results of an approximate linear theory, which allows to predict the closed-loop poles with a root locus technique. The second part of the paper reports on experimental resul...
متن کاملSub-Picosecond Active Timing Control over Fiber Optic Cable
Two-way time transfer over fiber optic cable [l] has been demonstrated over long baselines [2] and has been used recently to provide coherence to enable L-Band interferometry. In order to support coherent interferometry at higher frequencies and enable other high precision applications over long baselines, an active control concept was developed that enables sub-picosecond control of the propag...
متن کاملModeling and Control of Marine Cable Systems
x Develop, analyze, and experimentally verify coupled mechanical/fluid models for marine cables that can be used for control system design. Although there has been significant research in this area, most of the models are too complex to be used for model-based control system development. This research distills and combines the important physics of current models. x Design and experimentally imp...
متن کاملCable Anatomy I: Understanding the Speaker Cable
How big should the conductors be? The required size (or gauge) of the conductors depends on three factors: (1) the load impedance; (2) the length of cable required; and (3) the amount of power loss that can be tolerated. Each of these involves relationships between voltage (volts), resistance (ohms), current (amperes) and power (watts). These relationships are defined with Ohm’s Law. The job of...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JSME international journal. Ser. C, Dynamics, control, robotics, design and manufacturing
سال: 1995
ISSN: 1340-8062
DOI: 10.1299/jsmec1993.38.260