Acousto-ultrasonic monitoring of glueline curing. Part II. Gel and cure time
نویسندگان
چکیده
منابع مشابه
UV - LED Overview Part II — Curing Systems
Te ch ni ca l P ap er UV-LED Overview Part II — Curing Systems By Jennifer Heathcote This article is the second installment in a three-part series designed to consolidate key principles and technical information regarding the science and engineering behind ultraviolet light-emitting diodes (UV-LEDs). If you have not yet read “Part I— Operation and Measurement” in the July/August 2010 issue, you...
متن کاملUltrasonic Cure Monitoring of Photoresist During Pre-Exposure Bake Process
We have developed a sensor to measure the glass transition temperature (T,) of photoresist during its pre-exposure bake. During prebake, the resist must reach this temperature in order for significant solvent evaporation to occur. To determine T, we measured the change in phase of a high frequency pulse as it was reflected from the interface between an 8” silicon wafer and a photoresist film. T...
متن کاملViscothermal Wave Propagation including Acousto-elastic Interaction, Part Ii: Applications
In Part I of the present paper a parameter analysis showed that the most e$cient model to describe viscothermal wave propagation is the low reduced frequency model. In order to demonstrate the wide range of applicability of the low reduced frequency model, a number of examples from the literature are discussed in Part II. An overview of fundamental solutions and general applications is given. B...
متن کاملLight curing of dual cure resin cement
266 This is an Open Access article distributed under the terms of the Creative Commons Attribution Non-Commercial License (http://creativecommons.org/licenses/ by-nc/3.0) which permits unrestricted non-commercial use, distribution, and reproduction in any medium, provided the original work is properly cited.
متن کاملAn Advanced Multi-Sensor Acousto-Ultrasonic Structural Health Monitoring System: Development and Aerospace Demonstration
A key longstanding objective of the Structural Health Monitoring (SHM) research community is to enable the embedment of SHM systems in high value assets like aircraft to provide on-demand damage detection and evaluation. As against traditional non-destructive inspection hardware, embedded SHM systems must be compact, lightweight, low-power and sufficiently robust to survive exposure to severe i...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: NDT & E International
سال: 1992
ISSN: 0963-8695
DOI: 10.1016/0963-8695(92)90597-a